Creda S230G installation instructions Using the TOP Oven

Page 15

USING THE TOP OVEN

Note: DO NOT allow young children near to the appliance when the top oven is in use as the surfaces get hot

WARNING: Items stored in the top oven will get hot when the main oven is in use.

The top oven can be used to cook small quantities of food or used in conjunction with the main oven to provide additional cooking space.

SHELF POSITIONING

The shelf can be used in three different positions. It has a safety stop to prevent it being pulled out too far when attending to food. The shelf is removed from the oven

by pulling it out to the stop and the lifting at the front to withdraw.

TOP OVEN UTENSILS

The baking dish and the grill pan without the handle can be used in the oven. To ensure good air circulation in the oven, the maximum size of baking tray that should be used is 300mm X 350mm (12" X 14").

USING THE TOP OVEN

1.Check that the timer is set to manual.

2.Place the shelf in the correct position. ( see cooking chart ).

3.With the top oven door closed, push in and turn the control knob fully anti-clockwise. Sparking will continue until the burner is lit. Turn the control knob clockwise to the required setting (see cooking chart ). There is a delay of about one minute whilst the safety device operates before the burner comes fully on.

4.To turn off, turn the control knob clockwise to the symbol O.

NOTE: The oven burner only operates when the oven door is closed. The oven burner will shut off when the door is opened, and will turn on and reignite when the door is closed again.

GUIDANCE ON USING THE TOP OVEN

1.Best results are obtained by pre - heating for about fifteen minutes.

2.The tray or dish on which the food is cooked should be pushed to the back of the shelf.

3.Food which is higher than or will rise above 100mm (4") cannot be cooked in the top oven.

PLATE WARMING

Place the plates / dishes on the bottom shelf position and turn the control knob to mark 1 for 10 - 15 minutes. Never use the grill for warming plates.

COOLING FAN

A gentle flow of air will be blown below the control panel when any control is used. Whenever the appliance has been used, the cooling fan may continue to run or restart itself after all the controls have been turned off.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Europa S230G Creda Answer Centre 08701 54 64 Contents Introduction Always For Your SafetyNever Oven Timer Operation Automatic CookingHints on Automatic Cooking Clockface Know Your TimerSymbols Timer Function ButtonsSetting the Minute Minder Setting the Time of DAYAuto Cooking Programmes Electronic Clock & Automatic Oven Timer Operation Other Notes on Timer Operation ABC Grill PAN & HandleCooling FAN Using the GrillUsing the TOP Oven Shelf position 1 is the highest TOP Oven Cooking ChartYeast Mixtures Using the Main Oven Main Oven UtensilsMain Oven Operation Cold Start Cooking Using the ‘S’ Setting Main Oven Cooking Chart Small cakes 2 trays Mins Tray Victoria sandwich 2x8 205mm Care and Cleaning Credaclean Oven Liners Main Oven onlyCleaning GRILL, TOP Oven and Main Oven Replacement of the Oven Lamp HOW to Clean the Lamp LensOven Doors Cleaning the Doors Installation Instructions Ventilation InstallationFinal Installation GeneralTall Cabinet Ventilation 597mm Cabinets Less than 565mm Deep Connecting to GAS SupplyConnect to a 230-240V A.C. Supply only Electrical ConnectionInstallation and Operational Checks Something WRONG? Problem CheckPage Page Key Contacts

S230G specifications

The Creda S230G is a versatile and powerful electric storage heater that combines advanced technology with user-friendly features to provide efficient heating solutions for homes and commercial spaces. Designed with a modern aesthetic, the S230G seamlessly integrates into various interior designs while providing optimal warmth and comfort.

One of the standout features of the Creda S230G is its advanced energy storage capability. This heater operates by charging during off-peak energy hours, allowing users to take advantage of lower electricity rates. The unit stores heat in its ceramic bricks, which then gradually release warmth throughout the day, ensuring a consistent and comfortable indoor temperature. This not only promotes energy efficiency but also helps in reducing overall heating costs.

The Creda S230G is equipped with a built-in thermostat that allows for precise temperature control. Users can easily set their desired temperature, and the heater will automatically adjust its output to maintain that level of comfort. Additionally, the S230G features a manual control panel, making it easy to operate and customize heat settings to suit individual preferences.

Another notable technology integrated into the Creda S230G is its adaptive control system. This innovative feature learns the user's heating patterns and preferences over time, optimizing its performance to meet specific needs. This personal touch enhances comfort while ensuring energy is used efficiently, contributing to lower utility bills.

The heater's construction is robust, featuring high-quality materials that ensure durability and longevity. Safety is also a priority, with built-in overheat protection and a thermal cut-out feature designed to prevent potential hazards.

Installation of the Creda S230G is straightforward, making it a practical choice for both new builds and retrofitting projects. The unit can be mounted on walls to save space, and its compact size allows it to fit into various room layouts without being intrusive.

In summary, the Creda S230G stands out as an exceptional electric storage heater. Its energy-efficient design, user-friendly features, adaptive control system, and high-quality construction make it a reliable choice for heating needs. With the capability to provide consistent warmth while optimizing energy usage, the S230G is an ideal solution for those looking to enhance their living or working environment with effective heating technology.
Top Page Image Contents