Creda S230G installation instructions Something WRONG?, Problem Check

Page 33

SOMETHING WRONG?

Before calling a Service Engineer, please check through the following lists.

THERE MAY BE NOTHING WRONG.

Problem

Check

 

 

Nothing works.

If the timer display is blank.

 

Then it is likely that there is no electricity supply to your oven.

 

Check: (i) That the main cooker wall switch is turned on.

 

(ii) Check other appliances to see if you have a power cut.

 

(iii) Check the main circuit breaker for the property.

 

 

Display shows 0.00 AUTO.

The power supply to your oven has possibly been interrupted, but has

 

now come back on again. Reset the timer to the correct time of day and

 

"Manual" operation using instructions given in the timer section of the

 

book.

 

 

Timer display shows " Auto " lit

To use the ovens or grill the timer must be set to manual mode. See timer

up or flashing.

instructions.

 

 

 

Timer display correct but

The appliance incorporates a safety device to shut down the burners in

appliance will not operate

the event of a fault, to prevent overheating.

 

In this case contact your service engineer to have the fault rectified and

 

the safety device reset.

 

 

Can not set an “Auto Cook”

Remember that " Cook period " is the actual length of time for which the

programme

timer will switch the oven(s) on as part of an "Auto cooking " pro-

 

gramme.

 

 

Draught from beneath control

A gentle flow of air will be blown from beneath the control panel when

panel.

the appliance is used. If the appliance is still warm, this cooling fan may

 

continue to run, or restart itself after all controls have been turned off.

 

The fan will stop once the appliance has cooled.

 

 

Cooling fan not operating

If no air is blown from below the control panel when the controls are

 

switched on and you have checked through the " Nothing works "

 

section above, then the cooling fan may be faulty. In this case you should

 

turn off the appliance and contact your service agent to arrange for a

 

repair.

 

 

Oven burner not working

Note that the oven burners only operate when the door is closed to

 

ensure safe operation and avoid wasting heat. With the door closed the

 

oven burner will ignite.

 

 

Oven appears to be cooking at

It may be necessary to turn to a lower setting than shown on the cooking

too high a temperature.

chart or recipe as results depend on personal tastes.

 

If the oven appears to be cooking at too high a temperature than

 

previously, and turning down the thermostat has no effect, then the

 

thermostat may be faulty and you should contact your service agent.

 

 

Timer buzzer/bleeper operates

Buzzer / bleeper should stop automatically after two minutes. If not.

continually

press minute minder button to silence.

 

 

If you have been through the above list and there is still a problem; contact our Service department

(see Key Contacts, back page).

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Europa S230G Creda Answer Centre 08701 54 64 Contents Introduction Always For Your SafetyNever Oven Timer Operation Automatic CookingHints on Automatic Cooking Symbols Know Your TimerTimer Function Buttons ClockfaceSetting the Minute Minder Setting the Time of DAYAuto Cooking Programmes Electronic Clock & Automatic Oven Timer Operation Other Notes on Timer Operation ABC Grill PAN & HandleCooling FAN Using the GrillUsing the TOP Oven Shelf position 1 is the highest TOP Oven Cooking ChartYeast Mixtures Using the Main Oven Main Oven UtensilsMain Oven Operation Cold Start Cooking Using the ‘S’ Setting Main Oven Cooking Chart Small cakes 2 trays Mins Tray Victoria sandwich 2x8 205mm Care and Cleaning Credaclean Oven Liners Main Oven onlyCleaning GRILL, TOP Oven and Main Oven Replacement of the Oven Lamp HOW to Clean the Lamp LensOven Doors Cleaning the Doors Installation Instructions Final Installation InstallationGeneral VentilationTall Cabinet Ventilation 597mm Cabinets Less than 565mm Deep Connecting to GAS SupplyConnect to a 230-240V A.C. Supply only Electrical ConnectionInstallation and Operational Checks Something WRONG? Problem CheckPage Page Key Contacts

S230G specifications

The Creda S230G is a versatile and powerful electric storage heater that combines advanced technology with user-friendly features to provide efficient heating solutions for homes and commercial spaces. Designed with a modern aesthetic, the S230G seamlessly integrates into various interior designs while providing optimal warmth and comfort.

One of the standout features of the Creda S230G is its advanced energy storage capability. This heater operates by charging during off-peak energy hours, allowing users to take advantage of lower electricity rates. The unit stores heat in its ceramic bricks, which then gradually release warmth throughout the day, ensuring a consistent and comfortable indoor temperature. This not only promotes energy efficiency but also helps in reducing overall heating costs.

The Creda S230G is equipped with a built-in thermostat that allows for precise temperature control. Users can easily set their desired temperature, and the heater will automatically adjust its output to maintain that level of comfort. Additionally, the S230G features a manual control panel, making it easy to operate and customize heat settings to suit individual preferences.

Another notable technology integrated into the Creda S230G is its adaptive control system. This innovative feature learns the user's heating patterns and preferences over time, optimizing its performance to meet specific needs. This personal touch enhances comfort while ensuring energy is used efficiently, contributing to lower utility bills.

The heater's construction is robust, featuring high-quality materials that ensure durability and longevity. Safety is also a priority, with built-in overheat protection and a thermal cut-out feature designed to prevent potential hazards.

Installation of the Creda S230G is straightforward, making it a practical choice for both new builds and retrofitting projects. The unit can be mounted on walls to save space, and its compact size allows it to fit into various room layouts without being intrusive.

In summary, the Creda S230G stands out as an exceptional electric storage heater. Its energy-efficient design, user-friendly features, adaptive control system, and high-quality construction make it a reliable choice for heating needs. With the capability to provide consistent warmth while optimizing energy usage, the S230G is an ideal solution for those looking to enhance their living or working environment with effective heating technology.
Top Page Image Contents