Daewoo Microwave Oven, KOR-6N575S service manual

Page 12

4.Method to reduce the gap between the door seal and the oven front surface.

(1)To reduce gap located on part ‘A’

•Loosen the screw on stopper hinge top, and then push the door to contact the door seal to oven front surface.

•Tighten a screw.

(2)To reduce gap located on part ‘B’

•Loosen two screws on stopper hinge under, and then push the door to contact the door seal to oven front surface.

•Tighten two screws.

NOTE : A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm2.

11

Image 12

Contents Microwave Oven Table of Contents Safety and Precautions For Safe OperationSpecifications KOR-6N575SOuter Dimension External ViewFeature Diagram Safety interlock systemInstallation Leave space behind and sideVariable power cooking Operations and FunctionsDisassembly and Assembly To remove door assembly To remove cabinetTo remove door parts REF no Part Code Part Name Description ’TYPage To remove control panel parts QTYHigh voltage circuit wiring To remove magnetron To remove high voltage capacitorTo remove wind guide assembly To remove H.V.transformerInterlock Mechanism and Adjustment AdjustmentTroubleshooting Guide Trouble 1 Door shut, timer set, but no cooking takes placeYES Measurement of the Microwave Power Output ProcedureMeasurement and Test Procedures Microwave Radiation TestComponent Test Procedure High voltage transformerWiring Diagram Exploded View and Parts List Door AssemblyTotal Assembly Name Part Code Part Name Description QTY Daewoo Electronics Corp About this Manual