Daewoo Microwave Oven, KOR-6N575S service manual To remove high voltage capacitor

Page 14

6.To remove high voltage capacitor.

1)Remove the screw which secure the grounding ring terminal of the H.V. diode and the capacitor holder.

2)Remove the H.V. diode from the capacitor holder.

3)Reverse the above steps for reassembly.

High voltage circuit wiring

7. To remove magnetron.

1) Remove the screw which secure the magnetron.

2) Remove the magnetron.

3) Reverse the above steps for reassembly.

NOTE : Never install the magnetron without the metallic gasket plate which is packed with each magnetron to pre- vent microwave leakage. Whenever repair work is carried out on magnetron, check the microwave leakage. It shall not exceed 4mW/cm2 for a fully assembled oven with door normally closed.

Metallic

gasket

plate

Magnetron antenna

Cooling fin

Filament terminal

<MAGNETRON>

13

Image 14

Contents Microwave Oven Table of Contents Safety and Precautions For Safe OperationSpecifications KOR-6N575SOuter Dimension External ViewFeature Diagram Safety interlock systemInstallation Leave space behind and sideVariable power cooking Operations and FunctionsDisassembly and Assembly To remove door assembly To remove cabinetTo remove door parts REF no Part Code Part Name Description ’TYPage To remove control panel parts QTYHigh voltage circuit wiring To remove magnetron To remove high voltage capacitorTo remove wind guide assembly To remove H.V.transformerInterlock Mechanism and Adjustment AdjustmentTroubleshooting Guide Trouble 1 Door shut, timer set, but no cooking takes placeYES Measurement and Test Measurement of the Microwave Power OutputProcedure Procedures Microwave Radiation TestComponent Test Procedure High voltage transformerWiring Diagram Total Assembly Exploded View and Parts ListDoor Assembly Name Part Code Part Name Description QTY Daewoo Electronics Corp About this Manual