Continental Refrigerator Refrigerators and Freezers instruction manual Special Voltage Connections

Page 13

the condensing unit is 208-230 volts in which the wiring includes a neutral and a mechanical ground. This wiring should be connected to the appropriate power source by a qualified electrician and must conform to all local electrical codes.

SPECIAL VOLTAGE CONNECTIONS

When models are ordered from the factory with special, optional voltages, connections should be made as required on the electrical wiring diagram provided on the upper cabinet end panel next to the electrical console box.

START-UP CHECKLIST

After your model has been installed, leveled, cleaned, and electrically connected in accordance with this manual, please take the time before start-up to observe the following precautions to assure troublefree operation:

1.Check that all exposed refrigeration lines are free of severe dents or kinks.

2.Check the condenser fan and evaporator fans for freedom to rotate without any obstructions

3.Make sure that the cabinet is properly leveled (see "leveling" under installation and location section).

The system should run smoothly and quietly in accordance with generally accepted commercial standards. If any unusual noises are heard, turn the unit off immediately and check for any obstructions of the condenser or evaporator fans. Fan motors, fan blades, or fan housings can be jarred out of position through rough handling in transit or during installation.

Important Note: All freezer models have an energy-saving fan delay control to prevent the interior fans from operating until the evaporator becomes chilled. Therefore, on initial start-up, the fans will not turn immediately. This is a normal mode of operation. Allow sufficient time for the evaporator coil to reach its operating temperature (approximately 20 minutes).

Caution: If unit is unplugged or disconnected for any reason, allow several minutes (5-6 minutes) before turning the unit back on to allow the system pressures to equalize. Disregarding this procedure could cause an overload and prevent the unit from operating.

REMOTE APPLICATIONS

All models are available for purchase as remote models in which case the condensing unit is purchased separately and installed at the time of installation. All remote models are equipped with an expansion valve located within the evaporator coil housing, and both liquid and suction lines stubbed and extending out from the cabinet case top behind the front grill. Installation of the refrigeration accessories,

- 10 -

Image 13
Contents Reach-In Refrigerators and Freezers Operators Manual Table of Contents Troubleshooting and Servicing Guide Wiring Diagrams General Information and Important Operating Facts Receiving Your NEW ModelUncrating Your NEW Model Installation and Location ClearancesVentilation Floor Loads Mounting ROLL-IN Models in Place and Leveling Installing Legs and Leveling REACH-IN ModelsInstalling Casters and Leveling REACH-IN Models Installing Condensate Evaporator Require realignment, proceed as follows Removal of Doors and Door AdjustmentRemoval of Grill Initial Cleaning ProcedureVOLT, 60 HZ, 1 Phase Connection START-UP Procedure Electrical ConnectionsSpecial Voltage Connections START-UP ChecklistRemote Applications Thermometer Calibration OperationCalibration Check Dial ThermometerDigital Thermometer Refrigerator System and Adjustment Freezer System and Adjustment Defrost Operation LOW-PROFILE, CEILING-MOUNT Evaporator Assembly Evaporator AssemblyShelving Installation Interior REACH-IN AccessoriesOptional Interior Accessories Safety Precautions Precautions Maintenance Periodic Cleaning ProcedureSliding and Hinged Glass General Preventative MaintenanceModel # Serial # Troubleshooting and Servicing Guide Parts and ServiceNot start no hum Problem Probable Cause CorrectionCondensing unit runs Product zone Wiring Diagrams Page Page Page Page Page

Refrigerators and Freezers specifications

Continental Refrigerator is a leader in the manufacturing and design of high-quality commercial refrigerators and freezers. Renowned for their durability and reliability, Continental Refrigerators are a staple in restaurants, grocery stores, and other commercial food service establishments.

One of the standout features of Continental Refrigerators is their robust construction. Built with stainless steel and corrosion-resistant materials, these units are designed to withstand the rigors of a busy kitchen. The exterior is sleek and easy to clean, while the interior is designed for efficiency and organization, often featuring adjustable shelves and easy-access compartments.

In terms of technology, Continental Refrigerators utilize state-of-the-art refrigeration systems that ensure precise temperature control. With digital temperature displays and intuitive controls, users can easily monitor and adjust settings to meet specific storage needs. Many models come equipped with energy-efficient compressors and eco-friendly refrigerants, aligning with modern sustainability practices without sacrificing performance.

The cooling technology employed in Continental Refrigerators ensures rapid temperature recovery after door openings, which is critical for maintaining food safety standards. The units are designed with powerful fans that promote optimal air circulation, helping to ensure uniform temperatures throughout the interior.

Another significant characteristic is the noise reduction technology implemented in many Continental models. These refrigerators are engineered to operate quietly, contributing to a more pleasant working environment.

Additionally, Continental Refrigerators are built for versatility. They offer a range of options, from undercounter models to walk-in coolers, catering to various business sizes and needs. The ability to customize configurations ensures that businesses can maximize space while still maintaining access to essential refrigerated items.

Lastly, the brand is recognized for its customer support and warranty options, providing peace of mind for operators. Overall, Continental Refrigerators and Freezers combine durability, efficiency, and cutting-edge technology, making them an excellent choice for any commercial kitchen looking to maintain food safety and quality.