INSTALLING REFRIGERATOR IN
ENCLOSURE
FIG. 4
The transport support at the rear of the refrigerator can be removed if necessary for the installation of the refrig- erator in the enclosure. (See figure above).
NOTE: DO NOT install the appliance directly on carpeting. Carpeting must be removed or protected by a metal or wood panel beneath the appliance, which extends at least full width and depth of the appliance.
Caution: Use care when installing the refrigerator. This refrigerator is equipped with the latest vacuum insulated panel technology. These insulating panels are located on the Top, Back, Bottom, Sides and Doors of the refrig- erator.
If the surface is punctured, loss of insulation will occur, resulting in poor refrigerator performance.
NOTE: A wood strip must be in place across the upper opening of the enclosure. The top frame of the refrigera- tor will be anchored to the wood strip with screws, see FIG. 10.
The refrigerator must be installed in a substantial enclo- sure and must be level. When installing the refrigerator in the enclosure, all areas within the recess in which the refrigerator is installed must be sealed.
Make sure that there is a complete seal between the front frame of the refrigerator and the top, sides and bottom of the enclosure. A length of sealing strip is ap- plied to the rear surface of the front frame for this pur- pose, see FIG. 4. The sealing should provide a complete isolation of the appliance’s combustion system from the vehicle interior.
NOTE: Be careful not to damage the sealing strip when the refrigerator is put in place.
Securing the Refrigerator
After the refrigerator is put in place, (ensuring a com- bustion seal at the front frame), the refrigerator is to be secured in the enclosure with six screws (not included). The screws have to be installed in the following order:
STEP 1: Two screws installed through the front base,
which includes the lower front strip installation.
The refrigerator is provided with a lower front strip (shipped as a loose part). The front strip is to be attached after the refrigerator is set into the cutout opening.
1.Install the lower front strip by sliding it under the bottom hinge plates, as shown in FIG. 5.
FIG. 5
FIG. 6
2.Secure the refrigerator and the lower front strip with two screws: One screw through each hinge. See FIG 6.
6