Whirlpool GC1SHAXM manual Removing the Water & ICE Dispenser Board Interface, On the next

Page 27

REMOVING THE WATER & ICE DISPENSER BOARD INTERFACE

WARNING

Electrical Shock Hazard Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

Pull Out

Push Down

1.Unplug refrigerator or disconnect power.

2.Lift the overﬂow tray from the water and ice dispenser.

4.Disconnect the two edge connectors from the board interface and remove the hous- ing assembly.

Overﬂow Tray

Board Interface Edge Connectors

3.Push down on the bottom of the front cover housing of the water and ice dispenser, then pull the housing out at the bottom, and unhook it at the top (see the top photo in the right column).

Continued on the next page.

4-5

Image 27

Contents

Model GC1SHAXM 2003 69˝ HighGoals and Objectives ForwardTable of Contents Component Testing General Refrigerator SafetyModel & Serial Number Designations Model NumberSerial Number Model & Serial Number Label Tech Sheet Locations Page Cutout Dimensions Installation InformationHandle Removal Optional Door RemovalTools Required Before YOU BeginDoor Closing and Alignment Door Closing and Alignment Door Closing Door and Hinge ReplacementDoor Closing and Alignment Reverse Osmosis Water Supply Connecting to RefrigeratorWater Hookup Cold Water SupplyOverview Theory of OperationUser Interface Page Thermistors Electronic Control BoardDefrost Operation User Interface FAN Operation and DelayDefault Operation If Thermistors Fail Electronic ControlIN-DOOR ICE Page Component Locations Component AccessRemoving a Refrigerator or Freezer Light Bulb To remove the freezer light bulbTo remove the refrigerator light bulb Removing the Defrost Bimetal Removing the Refrigerator Thermistor Housing On the next Removing the Water & ICE Dispenser Board InterfaceInterface Board Screws Removing the Evaporator Tray Removing the Control Board Removing the Water Valves Removing the Condenser FAN Motor To remove the compressor terminal box To remove the run capacitor To remove the relay and overloadComponent Testing Chart Component TestingComponent Voltage AT Resistance / Watts Test Locations User Interface Control Board Diagnostics & TroubleshootingImportant Information Electronic Control BoardDisplay Is Blank Display Shows Error CodesSuggestions on Diagnosis Display Is NormalUser Interface Failure Feedback Failure Possible Cause Test PROCEDURE-ACTIONFailure Possible Cause Test PROCEDURE-ACTION Problem Possible Cause Test PROCEDURE-ACTION Troubleshooting ChartProblem Possible Cause Test PROCEDURE-ACTION Problem Possible Cause Test PROCEDURE-ACTION Electronic Control Board PIN Locations User Interface Board PIN Locations Thermistor Resistance / Temperature ChartPage Wiring Diagram Wiring Diagram & Strip CircuitsCondenser FAN Motor Evaporator FAN / DelayStrip Circuits CompressorDispenser Light Damper AIR Door MotorRefrigerator Light Freezer LightICE Chute Door Heater Freezer Door & Dispenser Housing HeatersWater Dispenser ICE DispenserPower & Communications Circuits Between Boards IDI ICE MakerThermistors Page Removing the Original Gasket Tech TipsInstalling the Service Gasket Product Specifications Warranty Information Sources For Technical Information and Service PointersFor Technical Assistance While AT the CUSTOMER’S Home Call