Whirlpool GC1SHAXM manual FAN Operation and Delay, Electronic Control, User Interface

Page 20

FAN OPERATION AND DELAY

Both the condenser and evaporator fan mo- tors operate on DC voltage. The control board supplies 115 volts AC to each motor, where it is converted to DC.

EVAPORATOR FAN

•Fan Start Delay—Fan is energized 3 minutes after the compressor starts.

•Fan Stop Delay—Fan is switched OFF 1 minute after the compressor stops.

•IMPORTANT: Evaporator fan shuts off when either the refrigerator or freezer door is opened.

CONDENSER FAN

•Fan start delay—Fan is energized 1 minute after the compressor starts.

•Fan stops when the compressor shuts off.

POWER FAILURE / TEMPERATURE RISE

This product has no audible alarm. However, it will alert the customer of a long power outage, or temperature rise, if the temperature rises above 17.6°F (–8°C). Should this occur, the following will happen:

•The “alert” will only be indicated on the freezer temperature display.

•The freezer temperature display blinks continually, and will show the actual freezer compartment temperature from the time the power is restored. If there are consecutive outages, the display will show the highest temperature for the entire period.

•The actual compartment temperature will display until the freezer COLD or COLDER keypad is pressed. The “alert” is terminated, and the display will revert back to the set temperature.

•All settings and memory are saved and are continued after power has been re- stored, i.e. FAST FREEZE, GROCERY SAVOR, and ice preference.

DEFAULT SETTINGS

If communication between the user interface and the control board is lost for more than 3 minutes, the user interface assumes the board is working correctly. The control board stores the current temperature settings, but will go into a “default mode,” and maintain preset temperatures. Once communication is restored, the stored settings are again used.

If communication is broken between the user interface and the control board during an “ON” cycle:

Electronic Control

•Default temperatures that will be main- tained are:

-Refrigerator section: 41°F (5°C).

-Freezer section: 0°F (–18°C).

User Interface

•Freezer display flashes “CF” and Set Temp alternately (Communication Fault).

•Refrigerator display flashes the Set Temperature.

•The user interface keypads will be dis- abled

•The ice maker will be disabled.

•The water filter status indicator light will blink, and the reset keypad will be disabled.

•The refrigerator and freezer interior lights will be off, except for the indicators above.

Default Operation If Thermistors Fail:

•Refrigerator thermistor fails:

-Damper and evaporator fan will be cycled “on” 15 minutes and “off” 30 minutes.

•Freezer thermistor fails:

-Compressor and evaporator fan will run continuously.

3-6

Page 19 Page 21
Image 20
Page 19 Page 21
Contents 2003 69˝ High Model GC1SHAXMForward Goals and ObjectivesTable of Contents Component Testing Refrigerator Safety GeneralSerial Number Model & Serial Number DesignationsModel Number Model & Serial Number Label Tech Sheet Locations Page Installation Information Cutout DimensionsDoor Removal Tools RequiredBefore YOU Begin Handle Removal OptionalDoor Closing and Alignment Door and Hinge Replacement Door Closing and Alignment Door ClosingDoor Closing and Alignment Connecting to Refrigerator Water HookupCold Water Supply Reverse Osmosis Water SupplyTheory of Operation OverviewUser Interface Page Electronic Control Board ThermistorsDefrost Operation FAN Operation and Delay Default Operation If Thermistors FailElectronic Control User InterfaceIN-DOOR ICE Page Component Access Component LocationsTo remove the refrigerator light bulb Removing a Refrigerator or Freezer Light BulbTo remove the freezer light bulb Removing the Defrost Bimetal Removing the Refrigerator Thermistor Housing Removing the Water & ICE Dispenser Board Interface On the nextInterface Board Screws Removing the Evaporator Tray Removing the Control Board Removing the Water Valves Removing the Condenser FAN Motor To remove the compressor terminal box To remove the relay and overload To remove the run capacitorComponent Testing Component Testing ChartComponent Voltage AT Resistance / Watts Test Locations Diagnostics & Troubleshooting Important InformationElectronic Control Board User Interface Control BoardDisplay Shows Error Codes Suggestions on DiagnosisDisplay Is Normal Display Is BlankFailure Possible Cause Test PROCEDURE-ACTION User Interface Failure FeedbackFailure Possible Cause Test PROCEDURE-ACTION Troubleshooting Chart Problem Possible Cause Test PROCEDURE-ACTIONProblem Possible Cause Test PROCEDURE-ACTION Problem Possible Cause Test PROCEDURE-ACTION Electronic Control Board PIN Locations Thermistor Resistance / Temperature Chart User Interface Board PIN LocationsPage Wiring Diagram & Strip Circuits Wiring DiagramEvaporator FAN / Delay Strip CircuitsCompressor Condenser FAN MotorDamper AIR Door Motor Refrigerator LightFreezer Light Dispenser LightFreezer Door & Dispenser Housing Heaters Water DispenserICE Dispenser ICE Chute Door HeaterThermistors Power & Communications Circuits Between BoardsIDI ICE Maker Page Tech Tips Removing the Original GasketInstalling the Service Gasket For Technical Assistance While AT the CUSTOMER’S Home Call Product Specifications Warranty Information SourcesFor Technical Information and Service Pointers

GC1SHAXM specifications

The Whirlpool GC1SHAXM is a highly acclaimed refrigerator that combines innovative technology with practical design, making it an ideal choice for modern households. One of its standout features is the 6th Sense Technology, which intelligently monitors and adjusts the temperature within the fridge and freezer compartments. This helps maintain optimal conditions for food preservation, ensuring that fruits, vegetables, and other perishables stay fresh for longer periods.

Another highlight of the Whirlpool GC1SHAXM is its spacious interior, designed to maximize storage and organization. With adjustable shelves and multi-purpose bins, users can customize the layout to accommodate various food items, from large containers to smaller essentials. The clever use of space also includes a dedicated fruits and vegetables crisper, which maintains the right humidity level to keep produce fresh and crunchy.

Energy efficiency is a key characteristic of the Whirlpool GC1SHAXM. The appliance is equipped with advanced insulation and a smart cooling system, which significantly reduces energy consumption without compromising performance. This not only helps save on electricity bills but also reduces the environmental impact of operating a refrigerator.

Additionally, the GC1SHAXM features a sleek, modern design that complements any kitchen décor. The elegant exterior is available in a variety of finishes, allowing homeowners to choose the style that best suits their taste. The intuitive control panel makes it easy to adjust settings and monitor temperature levels at a glance.

Whirlpool has also prioritized the ease of cleaning and maintenance in this model. The interior surfaces are designed with seamless edges and materials that resist stains and odors, ensuring that the refrigerator remains hygienic and easy to maintain. Moreover, the removable door bins and shelves simplify the cleaning process, making it convenient for users to keep their appliance in top condition.

In summary, the Whirlpool GC1SHAXM is a versatile refrigerator that combines state-of-the-art technology with user-friendly features. Its efficient cooling system, spacious design, energy-saving capabilities, and beautiful aesthetics make it a popular choice among homeowners looking for reliability and style in their kitchen appliances. Whether for a family of four or a bustling household, this refrigerator stands out as a valuable addition to any home.
Top Page Image Contents