Gas Connection, Installing the Gas Cooker

TO FIX THE COOKER TO THE REAR WALL

WARNING - For safety reasons and to prevent tipping of the appliance, these stabilizing means must be installed.

The cooker is equipped with 2 chains fixed on each side at the rear of the cooker near the top (see Fig. A). The chains are fitted with “spring clips” which must be clipped to the “screw eyes” provided with the cooker. Install the “screw eyes” as follows :

1. Drill four 6mm holes (position 1 - 2 - 3 - 4) in the wall as in Fig. A.

2.Insert part “R” into the holes then screw in the “screw eyes” part “G” see Fig. B.

Note: If the part provided is not suitable for the wall material please use an appropriate device to ensure secure holding of the “screw eyes” to the wall.

3.Bring the cooker near the wall and clip the chains on the

“screw eyes” as in Fig. C.

IMPORTANT: If the cooker is moved for any reason (e.g. maintenance) resulting in the cooker being unclipped from the wall, the cooker must be re-clipped to the wall at the completion of the task.

55 mm			mm
		55 mm	mm
		55 mm	76
			76
Position
2
		Position
		1
		chain	mm
Position		Position	550
Position		Position
3		4
Fig. A
Fig. B		Fig. C	wall
		wall
		G
G	R	Hole

GAS CONNECTION

Gas Installation must be made in accordance with AS5601; also refer to rangehood manufacturers recommendations.

Check gas pressure, note the correct setting from the data plate sealed inside the front appliance drawer * .

Installing the Gas Cooker:

(Flexible connections are NOT permitted with this appliance)

·An inlet manifold extension pipe must be fitted to the appliance. Part supplied in the drawer of the appliance.

·Ensure that the pipe is connected using the washer provided and that the bracket is screwed to the appliance as shown in the diagram below.

·Fit the supplied pressure regulator. Ensure the arrow is pointing towards the appliance and that the pressure test point is accessible from under the appliance when the product is pushed

back into the final position.

Push the cooker back and install the stabilizing chains. Connect the appliance inlet manifold to the fixed consumer piping outlet using only fixed piping. This final connection is made when the product is pushed back into position by access under the cooker.

Washer

Screw

	Inlet Manifold Extension.	Regulator
	Supplied with product.	Regulator
	Supplied with product.	Fixed Pipe to
	To be fitted by installer	Fixed Pipe to
		Connection Point

IT IS RECOMMENDED THAT A SERVICE TAP AND UNION BE FITTED ADJACENTTOTHE APPLIANCE INLET TO FACILITATE FUTURE SERVICING.

5 burner models: set the burner pressure to 1kPa for Natural Gas and 2.75kPa for U-LPG with the wok burner operating a full rate. For commissioning of the appliance with the Bromic regulator for Natural Gas , the test point pressure should be 1.00kPa with all burners operating on HIGH.

Apply a manometer to the test nipple and reset the regulator if necessary. Do not forget to replace the test nipple screw and to leave the instruction book with the user.

This appliance from the factory suitable for NATURAL gas but, if necessary, can be adjusted for U-LPG by authorised person. For the adjustments to U-LPG please operate as specified in the

paragraph GAS CONVERSION AND ADJUSTMENT (pag 4). The Gas Connection is male 1/2" BSP and is situated at the right or left, hand rear of the appliance, approximately 40mm from the side

The appliance shall be installed by an authorized person in accordance with the manufacturer’s installation instructions, relevant local fitting regulations, municipal building regulations, the AS5601 code for gas burning appliances and equipment and