SECTION 4—SEAT ASSEMBLY

WHEELCHAIR EQUIPPED WITH:

AVAILABLE MOUNTING HOLES FOR

 

FRONT ADJUSTABLE HEIGHT TUBE

 

 

 

 

 

 

ASBA SEAT WITH FOOTBOARD

A

B

C

D

E

OR FRONT RIGGINGS (NON-HEMI OR HEMI)

 

 

 

 

 

 

 

 

 

 

 

Rear Adjustable Height Tube

 

 

 

 

 

 

 

 

 

 

 

Mounted in hole A

N/A**

N/A**

N/A**

N/A**

N/A**

 

 

 

 

 

 

Mounted in hole B

N/A*

￿

￿

￿

￿

 

 

 

 

 

 

Mounted in hole C

N/A*

N/A*

￿

￿

￿

 

 

 

 

 

 

Mounted in hole D

N/A*

N/A*

N/A*

￿

￿

 

 

 

 

 

 

Mounted in hole E

N/A*

N/A*

N/A*

N/A*

￿

 

 

 

 

 

 

*NOTE: This mounting hole combination would result in a forward seat dump (the rear of the seat is higher than the front of the seat). The seat should never be adjusted to a position that results in a forward seat dump.

**NOTE: This mounting hole combination will cause interference between the front riggings and/ or the ASBA seat frame and wheelchair base. DO NOT use this mounting hole combination.

Removing/Installing the Adjustable Height Tubes

NOTE: For this procedure, refer to FIGURE 4.3.

NOTE: Reverse this procedure to install the adjustable height tubes.

1.Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on page 30.

2.Remove the desired side shroud from the wheelchair. Refer to Removing/Installing the Shrouds on page 74.

3.Remove the mounting screw and locknut securing the front adjustable height tube to the front support tube.

4.Remove the front adjustable height tube from the front support tube.

5.Remove the mounting screw and locknut securing the rear adjustable height tube to the rear support tube.

Part No 1118377

33

Pronto® M71™

Page 33
Image 33
Invacare M71 Removing/Installing the Adjustable Height Tubes, Asba Seat with Footboard Or Front Riggings NON-HEMI or Hemi