SECTION 4—SEAT ASSEMBLY
Pronto® M71™ 42 Part No 1118377
FIGURE 4.9 Removing/Installing the Back Canes
Replacing Seat Positioning Strap
NOTE: For this procedure, refer to FIGURE4.10.
1. Remove the seat cushion from the seat pan.
2. Move the flip back armrests out of the way. Refer to Adjusting Flip Back Armrests on
page 60.
3. Remove the two mounting screws, locknuts, washers and quick-release pin tabs that
secure the seat positioning straps to the seat frame.
4. Remove the two halves of the seat positioning strap from the rear seat frame.
5. Reposition the two new seat positioning strap inside of the seat frame as shown.
6. Reinstall the two mounting screws and quick-release pin tabs that secure the seat
positioning straps to the seat frame and torque to 75 in-lbs.
7. Reinstall the seat cushion onto the seat pan.
FIGURE 4.10 Replacing Seat Positioning Strap
Lower Hex Screw
Upper Hex Screw
Washers
Cane Bracket
Back Cane
Locknuts
Slot
Seat Positioning Strap Halves
Mounting Screw
Mounting Screw
Quick-Release Pin Tab
Quick-Release Pin Tab
Locknuts
Washers
Mounting
Holes
Seat Frame
Seat Frame