Invacare M71 service manual Arm Service Procedures for Asba or Adjustable Asba Seat

SECTION 5—ARMS

Arm Service Procedures for ASBA or Adjustable ASBA Seat

WARNING

Make sure the flip back armrest release levers and height adjustment levers are in the locked position before using the wheelchair.

Removing/Installing Flip Back Armrest

NOTE: For this procedure, refer to FIGURE 5.6.

NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the arm sockets.

NOTE: Reverse this procedure to install the flip back armrest.

1.If necessary, disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 97.

2.Unlock flip back armrest by pulling flip back armrest release lever into the unlocked (horizontal) position.

3.Remove quick release pin securing the flip back armrest to the wheelchair frame.

4.Pull UP on the flip back armrest and remove the armrest from the arm sockets.

5.Repeat STEPS 1-4 for the opposite flip back armrest, if necessary.

Flip Back Armrest

Flip Back Armrest Release Lever

NOTE: ASBA shown. Adjustable ASBA works the same way.

Locked

(Vertical)

Rear Arm	Unlocked
Socket
	(Horizontal)
Quick
Release	Seat Frame
Pin
	Front Arm Socket

FIGURE 5.6 Removing/Installing Flip Back Armrest

Adjusting the Flip Back Armrest

NOTE: For this procedure, refer to FIGURE 5.7 on page 59.

1.Unlock top of flip back armrest by pulling height adjustment lever into the up (horizontal) position.

2.Adjust top of the flip back armrest to the desired height.

Pronto® M71™ 58 Part No 1118377