SECTION 10—BATTERIES/CHARGER
Pronto® M71™ 94 Part No 1118377
5. Disconnect battery cable(s) from battery(ies) terminal(s)/post(s) (DETAIL “A” of
FIGURE 10.4 or FIGURE 10.5).
A. NEGATIVE (-) BLACK battery cable from NEGATIVE (-) battery terminal/post.
B. POSITIVE (+) RED battery cable from POSITIVE (+) battery terminal/post.
Replacing the On-Board Battery Charger Fuse WARNING
DO NOT replace the battery charger fuse with anything other than a 250V 6.3 Amp
fuse. Otherwise, equipment damage and/or personnel injury may occur.
DO NOT attempt to remove the battery charger fuse with power applied to the
wheelchair. Otherwise, equipment damage and/or personnel injury may occur.
NOTE: For this procedure, refer to FIGURE10.6.
NOTE: The output of the battery charger is fused with a 250V, 6.3 amp fuse. The fuse holder is
located at the top of the charger as it is mounted to the wheel chair. This fuse should be checked first
before replacing the battery charger for improper operation. If it has been determined the charger
should be replaced. Refer to Replacing the On-Board Battery Charger on page95.
1. Turn off power and disconnect joystick. Refer to Disconnecting/Connecting the
Joystick on page 97.
2. Remove rear shroud. Refer to Removing/Installing the Shrouds on page 74.
3. Remove threaded fuse holder from top of charger next to battery charger cable and
perform one of the following:
A. If fuse is bad, replace with new 250V, 6.3 amp fuse.
B. If fuse is good, replace charger. Refer to Replacing the On-Board Battery Charger
on page 95.
4. Connect joystick and turn power on. Refer to Disconnecting/Connecting the Joystick
on page 97.
5. Perform one of the following:
A. If wheelchair functions, install rear shroud. Refer to Removing/Installing the
Shrouds on page 74.
B. If wheelchair does not function, replace charger. Refer to Replacing the On-Board
Battery Charger on page 95.