Invacare M71 service manual Depth Adjustment/Height Adjustment

SECTION 7—FRONT RIGGINGS/FOOTBOARD

WARNING

Make sure the detent balls are engaged with the outer edge of the tube - otherwise, injury and/or damage may result.

2.Adjust footboard to one of three mounting positions.

3.Install the quick release pin. Make sure the detent balls are engaged with the outer edge of the tube.

Height Adjustment

NOTE: For this procedure, refer to FIGURE 7.11.

1.Remove the quick release pin that secures the footboard assembly to the wheelchair frame.

2.Remove mounting screw, washer, bushing, locknut and two nylon washers that secure the footboard to the footboard support.

3.Align footboard mounting holes with one of three height adjustment mounting holes.

4.Using the mounting screw, washer, bushing, locknut and two nylon washers, secure the footboard to the footboard support.

5.Insert footboard support, with footboard attached, into the wheelchair frame and align wheelchair frame mounting holes with the desired depth adjustment mounting holes in the footboard assembly.

WARNING

Make sure the detent balls of the quick-release pin are fully released beyond the outer edge of the tube before operating the wheelchair. Otherwise, injury and/or damage may result.

Keep detent balls clean.

6.Using the quick release pin, secure the footboard assembly to the wheelchair frame. Make sure the detent balls are engaged with the outer edge of the tube.

Wheelchair Frame	Depth Adjustment Holes
	Height Adjustment Holes
	Nylon Washers
	Washer
Mounting Hole	Mounting Screws
Quick Release Pin
Footboard Support
Bushing	Footboard
Locknut

Bottom view

Quick Release

Pin

Detent Balls

Outer Edge of

Tube

FIGURE 7.11 Depth Adjustment/Height Adjustment

Part No 1118377 73 Pronto® M71™