SECTION 4—SEAT ASSEMBLY
Pronto® M71™ 38 Part No 1118377
FIGURE 4.6 Adjusting the Seat Depth
Removing/Installing Side Rails
NOTE: For this procedure, refer to FIGURE4.7 on page 39.
Removing Side Rails
1. Remove both armrests.
2. Remove the two hex screws, washer and lanyard securing the crossbars to the side rail.
3. Loosen, but DO NOT remove, the four hex screws securing the cane brackets to the
side rails.
4. Loosen, but DO NOT remove, the four hex screws securing the front arm sockets to
the side rails.
5. Use a screwdriver to gently tap the two roll pins out of the side rails.
6. Slide both cane brackets (with T-nuts and back canes) out of the slots in the side rails.
7. Slide both front arm sockets (with T-nuts) out of the slots in the side rails.
DETAIL “A” - SEAT
DEPTH
MEASUREMENT
Rear
Arm
Socket
Side Rail
Measure Distance
Cane
Bracket
Side Rail
Hex Screws
Front
Arm
Socket