SECTION 7—FRONT RIGGINGS/FOOTBOARD
Pronto® M71™ 68 Part No 1118377
Replacing Heel Loops
NOTE: For this procedure, refer to FIGURE7.4.
1. Note the position of hex bolt, coved washers and locknut for reinstallation.
2. Remove the hex bolt, coved washe rs and locknut that secure the l ower footrest to the
footrest support.
3. Remove the lower footrest.
4. Remove the mounting screw, spacer
and locknut that secure the existing
heel loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
NOTE: When securing heel loop to lower
footrest, tighten the mounting screw and
locknut until the spacer is secure.
FIGURE 7.4 Replacing Heel Loops
Raising/Lowering Elevating Front Riggings
NOTE: For this procedure, refer to FIGURE7.5.
1. Perform one of the following:
A. Raising - Pull back on the release
lever and raise front rigging to the
desired height.
B. Lowering - Support front rigging
with one hand away from the
release lever. Push release lever
downward with other hand.
FIGURE 7.5 Raising/Lowering Elevating
Front Riggings
Adjusting/Replacing Telescoping Front Rigging Supports

Van Seat

NOTE: For this procedure, refer to FIGURE7.6 on page 69.
NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not
interfere with the caster wheel rotation.
NOTE: Telescoping front rigging supports may be extended up to 2-inches from the wheelchair
frame in 1-inch increments. This adjustment does not affect seat depth.
Footrest Support
Hex Bolt
Mounting
Screw
Spacer
Heel
Loop
Locknut
Lower Footrest
Coved
Washer
Locknut
Release
Lever