SECTION 9—MOTORS

Removing/Installing the Motor Release Lever

NOTE: For this procedure, refer to FIGURE 9.2.

NOTE: Reverse this procedure to install the motor release lever.

1.If necessary, remove the side shroud. Refer to Removing/Installing the Shrouds on page 74.

2.Remove the cap from the motor release lever.

3.Remove the cotter pin, washer and mounting pin securing the motor lock to the motor release lever. Set cotter pin and mounting pin aside.

4.Grasp the motor release lever by the end that attaches to the motor lock.

5.Pull the motor release lever through the lever support on the inside of the walking beam.

Walking Beam

Mounting Pin

and Washer

Walking Beam

Motor Lock

Motor Release Lever

(With Cap)

2-Pole

DC

 

Motor Release Lever

Cotter Pin

(With Cap)

FIGURE 9.2 Removing/Installing the Motor Release Lever

Part No 1118377

81

Pronto® M71™

Page 81
Image 81
Invacare M71 service manual Removing/Installing the Motor Release Lever