Invacare M71 Van Seat Service Procedures, Adjusting the Seat Position on Van Seat Frame

SECTION 4—SEAT ASSEMBLY

Van Seat Service Procedures

Adjusting the Back Angle

NOTE: For this procedure, refer to

FIGURE 4.17.

1.Lift up on the release handle and adjust back to desired angle.

2.Let go of the release handle to lock the back in position.

Back

Release Handle

FIGURE 4.17 Adjusting the Back Angle

Adjusting the Seat Position on Van Seat Frame

WARNING

For users over 250 lbs: The seat MUST be mounted in the furthest rearward position and the front seat posts MUST be in the 1-inch raised position or lower mounting holes A or B. Refer to Table: Available Mounting Holes on page 32 for available mounting positions

DO NOT adjust the rear seat posts higher than the front seat posts.

NOTE: For this procedure, refer to FIGURE 4.18 on page 52.

1.Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on page 30.

2.Remove the four bolts, four coved washers and two spacers securing the van seat to the seat frame.

3.Separate van seat from seat frame.

4.Refer to FIGURE 4.18 to determine the correct mounting holes to achieve the desired seat position on the seat frame.

5.Align the van seat mounting holes determined in STEP 4 with the seat frame mounting holes.

6.Secure the van seat to the seat frame using the four bolts, four coved washers and two spacers. Securely tighten.

7.Reinstall the seat assembly. Refer to Removing/Installing the Seat Assembly on page 30.

Part No 1118377 51 Pronto® M71™