SECTION 8—SHROUDS/FRAME
SECTION 8—SHROUDS/FRAME
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that ON/OFF switch on the joystick is in the OFF position.
Removing/Installing the Shrouds
NOTE: For this procedure, refer to FIGURE 8.1 on page 75.
WARNING
To prevent cracking the plastic shroud material, DO NOT overtighten the mounting screws.
NOTE: Reverse this procedure to install the shrouds.
1.Disconnect the joystick. Refer to Disconnecting/Connecting the Joystick on page 97.
2.Remove the seat assembly. Refer to Removing/Installing the Seat Assembly on page 30.
3.Perform one of the following:
A.Right and Left Side Shroud - Remove the five mounting screws that secure the shroud to the side frame assembly.
NOTE: Shorter mounting screws are used to secure the top rear of side shrouds (Detail “A” of FIGURE 8.1).
B.Shroud Plate - Remove the two mounting screws and washers securing the shroud plate to the side frame assembly (Detail “A” of FIGURE 8.1).
C.Front Shroud - Remove the two mounting screws that secure the front shroud to the base frame (Detail “B” of FIGURE 8.1).
D.Rear Shroud - Perform one of the following:
i.BEFORE 7/14/03 - Rotate knob 90° and remove rear shroud from base frame (Detail “B” of FIGURE 8.1).
ii.AFTER 7/14/03 - Remove the two mounting screws securing the rear shroud to the base frame and remove rear shroud from base frame (Detail “C” of FIGURE 8.1).
Pronto® M71™ | 74 | Part No 1118377 |
