Invacare M71 service manual Removing/Installing Side Rails

SECTION 4—SEAT ASSEMBLY

8. Pull both side rails off the crossbars.

Installing Side Rails

1. Install new side rails onto crossbars.

NOTE: Ensure long end of side rail is towards the front of the wheelchair.

2.Secure the side rails to the crossbars with the hex screws, washer and lanyard. Torque to 75 in-lbs.

3.Slide cane brackets (with T-nuts and back assembly) into the slots in the side rails.

4.Slide front arm sockets (with T-nuts) into the slots in the side rails.

5.Use a rubber mallet to tap the two roll pins into the side rails.

6.Tighten the four hex screws to secure the cane brackets to the side rails. Torque to 13 ft-lbs.

7.Install the armrests.

NOTE: It may be necessary to slide the front arm sockets to the proper position to install the armrests.

8.Tighten the four hex screws to secure the front arm sockets to the side rails. Torque to 13 ft-lbs.

	Side View	Cane Bracket	Front Arm
Back			Socket
		Slot
Cane

Side Rail

Crossbar

Hex Screws

Washer

Roll

Pin

Hex Screws

FIGURE 4.7 Removing/Installing Side Rails

Part No 1118377 39 Pronto® M71™