SECTION 7—FRONT RIGGINGS/FOOTBOARD
Part No 1118377 67 Pronto® M71™
Adjusting Footrest Height

Model PHWH93 Front Riggings

NOTE: For this procedure, refer to FIGURE7.2.
1. Remove any accessory from the front rigging(s).
2. Remove the front rigging from the wheelchair. Refer to Installing/Removing Front
Riggings on page 66.
NOTE: Lay front rigging on a flat surface to simplify procedure.
3. Remove the hex bolt, coved washe rs and locknut that secure the l ower footrest to the
footrest support.
4. Reposition the lower footrest to the
desired height.
5. Reinstall hex bolt, coved washers and
locknut that secure lower footrest to
footrest support. Tighten securely.
6. Repeat STEPS 1-5 for the opposite side
of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the
wheelchair. Refer to Installing/
Removing Front Riggings on page 66.
FIGURE 7.2 Model PHWH93 Front
Riggings

Model PH904A and PHAL4A Front Riggings

NOTE: For this procedure, refer to FIGURE7.3.
1. Loosen, but DO NOT remove the lug
bolt and locknut that secure the lower
footrest to the footrest support.
2. Reposition the lower footrest to the
desired height.
3. Securely tighten the lug bolt and
locknut that secure the lower footrest to
the footrest support.
4. Repeat STEPS 1-3 for the opposite side
of the wheelchair footrest, if necessary. FIGURE 7.3 Model PH904A and PHAL4A
Front Riggings
Coved Washer
Hex Bolt
Lower
Footrest
Coved
Washer
Locknu Footrest Support
Footrest
Support
Lug Bolt
Locknut
Lower Footrest
NOTE: PH904A style front rigging shown.
PHAL4A front rigging adjust the same way.