To replace the shelf:
NOTE: Make sure that both of the rear shelf slides are securely in the track before letting go of the shelf. The lateral shelf may be difficult to install if the track is placed too close to the refrigerator ceiling. Reposition the track on a lower rung until the shelf can be tilted enough to easily slide into the track.
1.Hold the shelf at the front and tip the front at a 45° angle to the track.
2.Insert both of the rear shelf slides into the upper channel of the track, and lower the front of the shelf into place.
Flip-up Shelf
(on some models)
1.To raise the shelf, pull forward on the lever located at the bottom front of the shelf and lift until the shelf locks into the vertical position.
2.To lower the shelf, lower the shelf until it is latched securely in place.
Adjustable Flip-up Shelf
(on some models)
To raise and lower the shelf:
1.Raise the shelf by first sliding it back and down to make it
2.Lift the front of the shelf until it fits securely in place against the back wall.
3.Lower the shelf securely back into position.
4.Pull the front of the shelf forward until it fits into place.
Deli Drawer
(on some models)
The deli drawer stores raisins, nuts, spreads, and other small items at normal refrigerator temperatures.
To remove and replace the deli drawer:
1.Remove the deli drawer by sliding it straight out to the stop. Lift the front and slide the drawer out the rest of the way.
2.Replace the deli drawer by sliding it back past the stop.
Convertible Vegetable/Meat Drawer,
Crisper and Covers
(on some models)
To remove and replace the crisper and convertible vegetable meat drawers:
1.Slide crisper or meat drawer straight out to the stop. Lift the front of drawer with one hand while supporting the bottom of drawer with other hand and slide the drawer out the rest of the way.
2.Replace the crisper or meat drawer by sliding it back in fully past the drawer stop.
HIGH | LOW |
To remove and replace the crisper or vegetable/meat drawer covers:
1.Remove the crisper and meat drawer. Press up in center of crisper glass insert until it rises above the plastic frame. Holding the crisper glass firmly, carefully slide the glass insert forward to remove.
2.Lift crisper cover frame up and remove. Repeat steps to remove the meat drawer cover.
3.Replace back of meat drawer cover frame into supports on side walls of the refrigerator and lower the front of the cover frame into place.
4.Slide rear of glass insert into cover frame and lower front into place. Repeat steps to replace the crisper cover.
Meat storage guide
Store most meat in original wrapping as long as it is airtight and
Fresh fish or shellfish | use same day as purchased | |
Chicken, ground beef, variety meat (liver, etc.) | ||
Cold cuts, steaks/roasts | ||
Cured meats | ||
Leftovers - Cover leftovers with plastic wrap, aluminum foil, or plastic containers with tight lids.
14