Whirlpool W10200284A Water Filter Certifications, Water dispenser will not operate properly

Page 17

The water dispenser will not operate properly

WATER FILTER CERTIFICATIONS

■Refrigerator connected to a water supply and the supply shutoff valve turned on? Connect refrigerator to water

supply and turn water shutoff valve fully open.

■ Kink in the water source line? Straighten the water source line.

■ New installation? Flush and fill the water system. See “Water Dispenser.”

■ Is the water pressure at least 35 psi (241 kPa)? The water pressure to the home determines the flow from the dispenser. See “Water Supply Requirements.”

■ Water filter installed on the refrigerator? Remove filter and operate dispenser. If water flow increases, the filter may be clogged or incorrectly installed. Replace filter or reinstall it correctly.

■ Refrigerator door closed completely? Close the door firmly. If it does not close completely, see “The doors will not close completely.”

■ Recently removed the doors? Make sure the water dispenser wire/tube assembly has been properly reconnected. See “Refrigerator Door(s) and Drawer.”

■ Reverse osmosis water filtration system connected to your cold water supply? This can decrease water pressure. See “Water Supply Requirements.”

Water is leaking from the dispenser system

NOTE: One or two drops of water after dispensing is normal.

■ Glass not being held under the dispenser long enough? Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever.

■New installation? Flush the water system. See “Water Dispenser.”

■Recently changed water filter? Flush the water system. See “Water Dispenser.”

■Water on the floor near the base grille? Make sure the water dispenser tube connections are fully tightened. See “Refrigerator Door(s) and Drawer.”

Water from the dispenser is warm

NOTE: Water from the dispenser is only chilled to 50°F (10°C).

■New installation? Allow 24 hours after installation for the water supply to cool completely.

■Recently dispensed large amount of water? Allow 24 hours for water supply to cool completely.

■Water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water.

■Refrigerator connected to a cold water pipe? Make sure the refrigerator is connected to a cold water pipe. See “Water Supply Requirements.”

17

Image 17

Contents Refrigerator User Instructions Refrigerator SafetyRemove the Packaging Clean Before Using Installation InstructionsUnpack the Refrigerator Before You Throw Away Your Old Refrigerator or FreezerElectrical Requirements LocationRequirementsWater Supply Requirements Recommended Grounding MethodStyle Connect the Water SupplyReverse Osmosis Water Supply Style 2-French Doors Refrigerator Doorsand DrawerStyle 1-Standard Door Freezer drawer models Remove Doors and HingesFreezer door models Reverse Door Standard Door optionalReplace Drawer Front Remove Drawer FrontReplace Doors and Hinges Remove and Replace Freezer DrawerStandard Door Freezer Door Door Swing Reversal optionalHinge Screws Standard Door Freezer DrawerDoor Removal & Replacement Style 2-Freezer Drawer Models Adjust the DoorStyle1-Freezer Door Models Refrigerator USE Using the ControlsOpening and Closing Doors To Turn Off/OnIce Maker Crisper Humidity ControlWater Dispenser Dispensing WaterTo Clean Your Refrigerator CleaningRefrigerator Care Changing the Light BulbRefrigerator Operation TroubleshootingMotor seems to run too much Refrigerator seems noisyIce and Water Temperature and MoistureTemperature is too warm Water dispenser will not operate properly Water Filter CertificationsApplication Guidelines/Water Supply Parameters Product Data SheetsItems Excluded from Warranty Limited WarrantyThis limited warranty does not cover Disclaimer of Implied Warranties Limitation of RemediesPage Réfrigérateur Sécurité DU RéfrigérateurExigences demplacement Instructions D’INSTALLATIONDéballagedu réfrigérateur Avant de jeter votre vieux réfrigérateur ou congélateurSpécificationsélectriques Méthode recommandée de mise à la terreSpécifications del’alimentationen eau Alimentation en eau par osmose inverseRaccordement au réfrigérateur Raccordement de la canalisation deauRaccordement à une canalisation d’eau Style 2-Porte à deux battants Porteset tiroir du réfrigérateurStyle 1-Porte standard Style-1 Porte standard Déposer la façade du tiroir Réinstaller la façade du tiroirStyle 2-Portes à deux battants Porte standard Porte du compartiment de congélation Inversion du sens douverture des portes optionVis de charnière Portes à deux battants Charnières supérieuresStyle 2-Modèles de compartiments de congélation avec tiroir Ajustement de la porteStyle 1-Modèles de compartiments de congélation avec porte Humidity Control Commande dhumidité sur certains modèles Utilisation des commandesUtilisation DU Réfrigérateur Ouvertureet fermeture des portesDistributeur d’eau Machine à glaçonsSystème defiltrationde leau Distribution d’eauRemplacement du filtre à eau Remplacement del’ampoule d’éclairageEntretien DU Réfrigérateur NettoyageFonctionnement du réfrigérateur DépannageLe réfrigérateur ne fonctionne pas Le moteur semble trop tournerGlaçons et eau Température et humiditéLe réfrigérateur semble bruyant Les portes sont difficiles à ouvrirRemarque Cela indique une faible pression de leau Système de filtration d’eau intérieur Feuilles DE Données SUR LE ProduitGarantie Limitée Garantie DES Gros Appareils Ménagers Whirlpool CorporationArticles Exclus DE LA Garantie La présente garantie limitée ne couvre pasWhirlpool Corporation All rights reserved W10200283A SP PN W10200284A