Whirlpool W10270322A installation instructions Bare Wire Torque Specifications, Wire Awg Torque

3.Pull the conduit through the strain relief on cord/conduit plate on bottom of range. Allow enough slack to easily attach wiring to the terminal block.

A

B

Bare Wire Torque Specifications

Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m)

Wire Awg	Torque
8 gauge copper	25 lbs-in. (2.8 N-m)
6 gauge aluminum	35 lbs-in. (4.0 N-m)

5.Use Phillips screwdriver to connect the bare (green) ground wire to the range with the ground-link screw. The ground wire must be attached first and must not contact any other terminal.

6.Use ³⁄₈" nut driver to connect the neutral (white) wire to the center terminal block post with one of the 10–32 hex nuts.

	C
G	D
F	E
A. Terminal block	E. Neutral (white) wire
B. Ground-link screw	F. Line 1 (black) wire
C. Cord/conduit plate	G. Bare (green) ground wire
D. Line 2 (red) wire

4.Attach terminal lugs to line 1 (black), neutral (white), and line

2 (red) wires. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten setscrew to

XX lbs-in. torque. See Bare Wire Torque Specifications chart.

A

B

C D E

G

A

B

		F
	D	E
C
A. 10–32 hex nut		E. Neutral (white) wire
B. Line 1 (black)		F. Line 2 (red)
C. Bare (green) ground wire	G. Terminal lug

D.Ground-link screw

7.Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with 10-32 hex nuts.

8.Securely tighten hex nuts.

9.Replace terminal block access cover.

A. Terminal lug

B.Setscrew

C.Line 1 (black) wire

D.Neutral (white) wire

E.Line 2 (red) wire

12