Whirlpool W10270322A Verify Anti-Tip Bracket Location, Cord/conduit plate Line Black wire

Page 13

3-wire connection: Direct Wire

Use this method only if local codes permit connecting ground conductor to neutral supply wire.

1.Pull the conduit through the hole and conduit plate on bottom of range. Allow enough slack to easily attach the wiring to the terminal block.

A

B

 

 

C

 

 

D

F

E

 

 

 

A. Terminal block

D. Line 2

(red) wire

B. Ground-link screw

E. Bare (green) ground wire

C. Cord/conduit plate

F. Line 1

(black) wire

2.Attach terminal lugs to line 1 (black), bare (green) ground, and line 2 (red) wires. Loosen (do not remove) the setscrew on the front of the terminal lug and insert exposed wire end through bottom of terminal lugs. Securely tighten setscrew to XX lbs- in. torque. See Bare Wire Torque Specifications chart.

A

B

C D E

A. Terminal lug

B.Setscrew

C.Line 1 (black) wire

D.Bare (green) ground wire

E.Line 2 (red) wire

Bare Wire Torque Specifications

Attaching terminal lugs to the terminal block - 20 lbs-in. (2.3 N-m)

Wire Awg

Torque

8 gauge copper

25 lbs-in. (2.8 N-m)

 

 

6 gauge aluminum

35 lbs-in. (4.0 N-m)

 

 

3.Use ³⁄₈" nut driver to connect the bare (green) ground wire to the center terminal block post with one of the 10–32 hex nuts.

F

A

E

B

 

D

 

C

A. 10–32 hex nut

D. Bare (green) ground wire

B. Line 1 (black)

E. Line 2 (red)

C. Ground-link screw

F. Terminal lug

4.Connect line 1 (black) and line 2 (red) wires to the outer terminal block posts with 10-32 hex nuts.

5.Securely tighten hex nuts.

6.Replace terminal block access cover.

Verify Anti-Tip Bracket Location

1.Make sure the anti-tip bracket is installed.

Look for the anti-tip bracket securely attached to floor or wall.

2.If not direct wired, plug power cord into appropriate outlet.

3.Slide range back so rear range foot is engaged with anti-tip bracket. Check that the flexible conduit or power supply cord is not bent.

13

Image 13
Contents Freestanding Electric Range with Double Ovens Installation InstructionsYour safety and the safety of others are very important Range SafetyTools and Parts Installation RequirementsLocation Requirements 35⁷⁄₈ 91.4 cm 29⁷⁄₈ 75.9 cm 26⁵⁄₁₆ 27¼ 66.8 69.2 cm Product Dimensions Cabinet DimensionsIf connecting to a 3-wire system If connecting to a 4-wire systemElectrical Requirements Electrical ConnectionAdjust Leveling Legs Installation InstructionsUnpack Range Floor Mounting Install Anti-Tip BracketWall Mounting Direct Wire Power Supply CordStyle 1 Power supply cord strain relief Electrical Connection U.S.A. OnlyRemovable retaining nut Strain relief Style 2 Direct wire strain reliefWire connection Power Supply Cord Wire Connection Direct Wire Direct Wire Installation Copper or Aluminum WireWire Awg Torque Bare Wire Torque SpecificationsVerify Anti-Tip Bracket Location Cord/conduit plate Line Black wireLevel Range Complete InstallationIf range does not operate, check the following For direct-wired ranges For power supply cord-connected rangesMoving the Range W10270322A