Whirlpool SM980PEY warranty Lift-up cook-top, Surface Burners, Above

Page 23

Lift-up cook-top

1.Remove surface burner grates and reflector pans.

2.Lii front of cooktop at both front corners until the support rods lock into place.

l

l

Personal Injury and

Product Damge Hazard

Be sure both support rods are fully extended and in the locked position. Failure to do so could result in personal injury from the cooktop accidentally falling.

Do not drop the cooktop. Damage can resuft to the porcelain and the cooktop frame.

3.Wipe with warm, soapy water. Use a soapy steel-wool pad on heavily soiled areas.

4.To lower the cooktop, lift cooktop from both sides while pressing the support rods back to unlock them. Lower the cooktop into place.

Replace reflector pans and surface burner grates.

Surface	burners
1. Lift up the cooktop, following the instructions		Scrsws
above.

2.Before cleaning, remove screws that hold each of the burners in place. The screws prevent the burners from moving during shipment. Remove the shipping screws with a Phillips screwdriver and lift the burners up and out. This separates the burners from the mounting bracket under each burner pair.

3.Wipe off surface burners with warm, soapy water and a sponge after each use. To remove cooked-on food, soak the burners in a vinegar and water solution for 20-30 minutes. Scrub with a plastic scrubbing pad.

4.If ports are clogged, clean with a straight pin. DO NOT enlarge or distort the ports. DO NOT use a toothpick to clean the ports.

23

Image 23

Contents To the Installer Please Leave this GAS Cooktop and SELF-CLEANING Lower OvenFor more information, see the Theanti-tip bracket on Your safety is important to usThank you for buying a Whirlpool appliance ALL Ranges can TIPGeneral Important Safety InstructionsKnow where your main gas shutoff valve is located When using the cook-topGrease When usinn the ovenCare and cleaninn Lower Oven Control Panel Parts And FeaturesControl Surface Burner Control PanelThis Section Using Your Cooktop And Lower OvenUsing the surface burners Burner heat settingsCookware tips Case of a prolonged power failure6th oven rack position roasting rack Positioning racks and pansHome canning information Three or four pans For best air circulationPush in and turn the Minute Timer Knob to set the clock Setting the clockUsing the Minute Timer Baking/roasting Broiling Adjusting the oven temperature controlBroiling tips Rare steaks and fish Rack Position ChartEnergy saving tips FoodTo OFF Using the automatic Mealtimer clockTo delay start and stop automatically Handles left near the oven vent can When the oven is ON, pans and panOven To start baking/roasting now and stop automaticallyAnti-tip Bracket Storage drawerThis Section Pa*Page Using The Self-Cleaning CycleHow the cycle works Before you startTop Setting the controlsClean Special tips To stop the Self-Cleaning cycle at any timeSurface burner grates and reflector pans Caring For Your Cooktop And Lower OvenLift up the cooktop, following the instructions Lift-up cook-topSurface Burners Replace reflector pans and surface burner gratesTypical surface burner flame at hlghast setting Part Cleaning chartHOW to Clean Scrubbing pad Clean after each useSelf-Cleaning cycle Nonabrasive, plasticTo replace the oven light Lower oven lightBurner ports are clogged If You Need Assistance Or ServiceClean with a straight pin see pages 23 Before calling for assistanceSolwion Let dry Push control knobs in before turning to a settingIf you need FSP replace- ment parts If you need serviceIf you are not satisfied with how the problem was solved If you need assistancePage Full ONE-YEAR Microwave Overq/Range Product Warranty