Whirlpool SM980PEY warranty Let dry Push control knobs in before turning to a setting, Solwion

Page 29

PROBLEM

Burner flames are uneven

Burner flames lift df porte, am yellow, or are noisy when turned off

POSSIBLE CAUSE

Burner ports are clogged.

SOLWION

Clean with a straight pin (see pages 23 and 25). If this fails. call an authorized WhirlpoolStJservice technician for service.

Contact an authorized WhirlpoolSMservice technician to check air/gas mixture.

Burner makes popping noiee when on

Control knob(s) will not turn

Self-Cleaning cycle will not Dperate

Cooking result8 we not what you expected

Burner is wet from washing.

You are not pushing in before turning.

The Oven Selector and Oven Temperature Control are not set to CLEAN.

The range clock does not show the correct time of day.

The Lock Lever is not in the CLEAN position-all the way to the right.

The Start Time Dial does not show the correct time of day or the knob is not all the way out.

The Stop Time Dial is not set ahead to the time you want the cleaning cycle to stop.

The range is not level.

The oven temperature seems too low or too high.

The oven was not preheated as the recipe calls for.

The recipe has never been tested or is not from a reliable source.

The pans are not the type or size recommended in the recipe.

There is not proper air circulation around pan when baking.

Flame size does not fit the cooking utensil being used.

When broiling, you have not completely closed the oven door.

Let dry.

Push control knob(s) in before turning to a setting.

Set both the Oven Selector and Oven Temperature Control to CLEAN.

Reset clock to show the correct time of day. (See page 11.)

Move Lock Lever all the way to the right.

Reset the Start Time Knob to show the correct time of day. Pull knob out all the way.

See Step 3 in “Settingthe controls” on page 20 for proper setting instructions.

Level range. (See Installation Instruc- tions.)

Adjust the oven temperature control. (See “Adjustingthe oven temperature control” on page 13.)

Preheat oven if called for in recipe.

Use only tested recipes from a reliable source.

Refer to a reliable cookbook for recom- mended pan type and size.

Allow 1% to 2 inches (4-5 cm) on all sides of the pans for air circulation. There must be a minimum space of 1 inch (2.5 cm).

Adjust flame size to fit cooking utensil.

Completely close oven door.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents To the Installer Please Leave this GAS Cooktop and SELF-CLEANING Lower OvenThank you for buying a Whirlpool appliance Your safety is important to usALL Ranges can TIP For more information, see the Theanti-tip bracket onGeneral Important Safety InstructionsKnow where your main gas shutoff valve is located When using the cook-topGrease When usinn the ovenCare and cleaninn Control Parts And FeaturesSurface Burner Control Panel Lower Oven Control PanelUsing the surface burners Using Your Cooktop And Lower OvenBurner heat settings This SectionCookware tips Case of a prolonged power failure6th oven rack position roasting rack Positioning racks and pansHome canning information Three or four pans For best air circulationPush in and turn the Minute Timer Knob to set the clock Setting the clockUsing the Minute Timer Baking/roasting Broiling Adjusting the oven temperature controlBroiling tips Energy saving tips Rack Position ChartFood Rare steaks and fishTo OFF Using the automatic Mealtimer clockTo delay start and stop automatically Oven When the oven is ON, pans and panTo start baking/roasting now and stop automatically Handles left near the oven vent canAnti-tip Bracket Storage drawerHow the cycle works Using The Self-Cleaning CycleBefore you start This Section Pa*PageTop Setting the controlsClean Special tips To stop the Self-Cleaning cycle at any timeSurface burner grates and reflector pans Caring For Your Cooktop And Lower OvenSurface Burners Lift-up cook-topReplace reflector pans and surface burner grates Lift up the cooktop, following the instructionsTypical surface burner flame at hlghast setting Part Cleaning chartHOW to Clean Self-Cleaning cycle Clean after each use Nonabrasive, plastic Scrubbing padTo replace the oven light Lower oven lightClean with a straight pin see pages 23 If You Need Assistance Or ServiceBefore calling for assistance Burner ports are cloggedSolwion Let dry Push control knobs in before turning to a settingIf you are not satisfied with how the problem was solved If you need serviceIf you need assistance If you need FSP replace- ment partsPage Full ONE-YEAR Microwave Overq/Range Product Warranty
Top Page Image Contents