Setting Up Your Range
Cooktop Assembly
warning
To avoid the chance of fire, explosion or carbon monoxide poisoning, do not attempt to use your range without the burners completely and properly assembled. The burner rings spread the flame evenly around the burner cap. The burner rings must be properly seated for proper burner lighting and operation.
Stack Burners
Crown Burner
Burner Locations
Stack Burner Assembly
1.Put the burner rings on the burner bases as shown below. Match the correct sizes. The bottom of the correct size burner ring fits inside the top of the matching burner base.
2.Turn the ring until it drops into place. Twist each ring back and forth slightly to make sure it is properly seated.
3.Put the burner caps on top of the burner rings. The ridge around the bottom edge of the cap goes around the top of the burner ring.
Crown Burner Assembly
1.Put the burner head in place as shown below. The locating tab on the burner head goes in the keyed hole as shown.
2.Put the burner ring on the burner head as shown below. Match the tabs on the bottom of the ring to the slots on the burner head. Twist each ring back and forth slightly to make sure it is properly seated.
3.Put the burner cap on top of the burner ring. The ridge around the bottom edge of the cap goes around the top of the burner ring.
Step
Ridge on bottom of Burner Cap
Step | Burner Ring |
| |
Tabs |
|
Slots | Burner Head |
| |
Step |
|
Burner Base
Put locating tab into keyed hole
Keyed Hole
Crown Burner Assembly
Step
Ridge on bottom of
Burner Cap
Step
Burner Ring
Step
Burner Base
Stack Burner Assembly