Splash back Assembly
A stainless steel splash back is supplied with the appliance. This is meant to be fitted on the rear edge of the cooker's hob. The splash back is inserted into the polystyrene upper part of the package.
1.Carefully clean the hob top.
2.A foam rubber gasket is supplied into the instruction book envelope.
3.After cleaning the hob from possible grease and film residuals left, fix the gasket on the rear part of the hob, paying attention not to close the fan slots (Fig. 4).
4.Take the splash back out of the envelope and remove the protective film.
5.Insert the splash back into the proper hinges in the rear part of the hob (Fig. 5).
6.Fix the splash back with the supplied screws (Fig. 6).
Fig. 4
Fig. 5
FO 2347 |
FO 2286 |
Fig. 6
FO 2287
21