Best IP29M Series Prepare the Blower Housing, Remove the Filters and the Grease Drip Rail

Page 7

4. PREPARE THE BLOWER HOUSING

Detach the blower housing from the hood by removing its both retaining screws (A). Keep the screws for further use.

Fold up its both flanges (B). The flanges must be perpendicular to the top of the blower housing.

A

B

B

HD0229

5. REMOVE THE FILTERS AND THE GREASE DRIP RAIL

A.Remove tape on filters. Remove filters from hood and set aside.

NOTE: It is recommended to start with the central one.

B.Remove tape on grease drip rail (1). Lift out grease drip rail and set aside.

1

HD0222

6. REMOVE THE PAN
NOTE: Do not remove the 4 screws located on the
notched parts of the pan (A on figure below).
A	Using a Phillips no. 2, remove 8 screws
	retaining the pan (shaded part on	RETAINING SCREWS LOCATION
	illustration beside) to the hood.	RETAINING SCREWS LOCATION
		HD0224
	Remove the pan and set aside.
A
HD0223
		HD0238

- 7 -

Image 7

Contents IP29M Series Never Pick UP a Flaming PAN-You may be burned To Reduce the Risk of a Range TOP Grease FireBLOWER/ROUGH-IN KIT IP29M Series Range Hood System Interior BlowersIP29M Series Range Hood System IN-LINE and Exterior Blowers Model P6 Single Interior Blower Typical Ductwork Select Blower Option and Installation TypePrepare the Installation Measure InstallationRemove the Filters and the Grease Drip Rail Prepare the Blower HousingRemove the PAN Build the Framework Install the ROUGH-IN Plate in the Blower Housing Install Blower HousingSecure Blower Housing to Brackets Install Transition to ROUGH-IN Plate Interior Blower onlyInstall the Hood Connect the WiringReinstall Grease Drip Rail and Baffle Filters Reinstall the PANLight Bulbs Replacement Cooktop Lighting Halogen OperationOperation CONT’D Grease filter resetIP29M Series Service PartsONE-YEAR Limited Warranty Warranty