Install Blower Housing | Best IP29M Series guide

8. INSTALL BLOWER HOUSING

Use both screws (A) previously removed in step 4 to assemble the blower housing to the mounting brackets. For installation with decorative flue cover AEIWP Series only, place 4 nuts (B) (from flue cover parts bag) on the pem studs, leaving 1/4” for the hood installation. The blower housing must be installed in such a way that its label (C) will be on the same side as the hood control side. See illustrations below.

INSTALLATION WITH

DECORATIVE FLUE COVER AEIWP SERIES

	C
B	B
	B
HD0230	A

INSTALLATION WITH

DRY WALL TRIM ATDIP SERIES

	C
HD0231	A

9. SECURE BLOWER HOUSING TO BRACKETS

From the inside, secure the blower housing to mounting brackets, using 2 no. 8 x 3/8” screws per side.

Screws must be installed in embossed sections, see details beside.

RETAINING SCREWS LOCATION

HO0100

10.INSTALL TRANSITION TO ROUGH-IN PLATE (INTERIOR BLOWER ONLY)

Model 423, 424, 427 453, or 454

Attach transition (if required) to blower rough-in plate.

Use metal duct tape to make all joints secure and air-tight.

NOTE: Model P6 blower plate connects directly to 7’’ round ductwork without a transition.

HO0086

11.INSTALL THE ROUGH-IN PLATE IN THE BLOWER HOUSING

Run power cable to installation location. Refer to the instructions included with the selected blower/rough-in kit (sold separately) for details on installing the rough-in plate. Install the rough-in plate so that the wiring box is located on the right side when facing the hood, as specified on the blower housing label.

Connect transition or rough-in plate to ductwork. Use metal duct tape to make all joints secure and air-tight.

WIRING COVER

HD0232

- 9 -