www.zephyronline.com
USING THE REMOTE CONTROL
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
The remote control may operate in humid environments, but not when placed on wet surfaces.
Selecting the Suction Speed position the remote control vertically near the cook top area and rotate clockwise to increase the suction speed, and anticlockwise to decrease the suction speed.
Turning on the Light, press the remote control from the top downwards once for dim lighting, again for full lighting, and again to turn off the light.
If the cooker hood’s Control Ball flashes
Remote Control Maintenance:
Clean the remote control using non abrasive detergents.
Follow the instructions below in order to replace the batteries for the remote control :
Using a small screwdriver, raise the cover on the base of the remote control, in order to access the battery compartment. Remove the battery holder, and replace 4 new batteries type ..394 of 1.5V.
Place the batteries in order in the battery holder (see illustration) taking care to respect the polarities indicated on the base of the upper section of the remote control.
Warning!
If the remote control doesn’t work after installation (yet the control ball works correctly), do the following:
1.Place the remote control on the work surface near the hood.
2.Disconnect the hood from the mains.
3.Reconnect the hood to the mains.
Follow this procedure whenever the remote control doesn’t work for no apparent reason (e.g.: dead battery).
Description of the hood - Remote Control
17