C. Screw the four 1" wood screws (for mounting the hood) into the exact center of the arrow and into the keyhole mounting slots marked on the cabinet bottom (for flush installations), or marked on the 1”x2” wood strips (for recessed cabinet installation) (Fig.7) Do not turn the mounting screws in all the way. Allow 3/8" of screw to project, so the hood can be fitted place.
(The screws will be tightened later)
Strips secured
Fig.7
G. Providing Electrical Power
1.After turning off the proper 120 volt circuit at the service entrance, drill out the electrical power line access hole marked on the cabinet bottom or wall. Use a 1¼”wood bit. (Fig. 8)
2.Fish the electrical power line through the access hole drilled in the wall or bottom of the cabinet. Attach an appropriate connector (purchased locally) to the end of the power line for the type of wiring being installed. Follow all codes. (Fig.9)
Safety Warning:
If drilling into the walls, be careful not to cut existing electrical cables, which would create a hazard.
1 
" bit
Fig.8
Color:
green/white/black
Connecter
Fig.9
7