Seagate 1080SL manual Connector and jumper block locations

Page 8

6	Medalist 1080sl SCSI Installation Guide, August 1995

J8. Options jumper block

J8 pin 1

J1 pin 1

J1. Interface connector

J3. Standard power connector

1	2	3	4	Circuit

board

+5V

+5V return

+12V return

+12V

Figure 1. Connector and jumper block locations

Image 8

Contents Medalist 1080sl Scsi Interface Drive Contents Introduction Drive features Read before you begin Medalist 1080sl Scsi Installation Guide, August Configuring the drive Required materialsConnector and jumper block locations Options jumper settings Medalist 1080sl Scsi Installation Guide, August Medalist 1080sl Scsi Installation Guide, August Attach an available power cable to the drive Attaching cablesMounting the drive Mounting hole locationsLow-level formatting Configuring the drive and computerSystem setup configuration Partitioning High-level formatting Network installation NonDOS operating systemsBasic troubleshooting Medalist 1080sl Scsi Installation Guide, August Advanced troubleshooting System error message, Drive not Ready, appears Screen stays blank when you power up the systemFdisk error message, No Fixed Disk Present, appears Location Modem number Technical support servicesSeaBOARD SeaFAX Location Telephone numberSeagate Technical Support FAX /438-8137 SeaFONE /438-8222Seagate’s Internet connections SeaTDD /438-5382Seagate CompuServe forum Storing and shipping your drive Drive in an approved package

Related manuals

Manual 40 pages 58.08 Kb