Seagate 1080SL manual Options jumper settings

Page 9

Medalist 1080sl SCSI Installation Guide, August 1995

7

J8. Options jumper block

33 31 29 27 25 23 21 19 17 15 13 11 9 7 5 3 1

34 32 30 28 26 24 22 20 18 16 14 12 10 8 6 4 2

Circuit board side up.

Note.

1.All other pins are reserved. Do not use them.

2.Jumpers on pins 28 and 30 and 32 and 34 are spares; these pins do not require jumpers.

Spares

SCSI ID 0

SCSI ID 1

SCSI ID 2

SCSI ID 3 (default)

SCSI ID 4

SCSI ID 5

SCSI ID 6

SCSI ID 7

Reserved

Do not use

Remote LED connection

Remote start

Enable parity (default)

Disable terminator (default is enable)

Power to drive terminator only

Power from bus, drive terminator disabled

Power to drive terminator and to SCSI bus (default)

Power to SCSI bus only

Figure 2. Options jumper settings

Image 9
Contents Medalist 1080sl Scsi Interface Drive Contents Introduction Drive features Read before you begin Medalist 1080sl Scsi Installation Guide, August Required materials Configuring the driveConnector and jumper block locations Options jumper settings Medalist 1080sl Scsi Installation Guide, August Medalist 1080sl Scsi Installation Guide, August Attaching cables Attach an available power cable to the driveMounting hole locations Mounting the driveConfiguring the drive and computer System setup configurationLow-level formatting Partitioning High-level formatting NonDOS operating systems Network installationBasic troubleshooting Medalist 1080sl Scsi Installation Guide, August Advanced troubleshooting Screen stays blank when you power up the system System error message, Drive not Ready, appearsFdisk error message, No Fixed Disk Present, appears Technical support services SeaBOARDLocation Modem number Location Telephone number SeaFAXSeagate Technical Support FAX /438-8137 SeaFONE /438-8222SeaTDD /438-5382 Seagate CompuServe forumSeagate’s Internet connections Drive in an approved package Storing and shipping your drive
Related manuals
Manual 40 pages 58.08 Kb