STAND ALONE INSTALLATION
***This installation only applied with the purchase of a duct cover.
SAFETY WARNING
HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES IF IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING.
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.
-Decide the location of the venting pipe from the hood to the outside. Refer
-A straight, short venting run will allow the hood to perform more efficientl
-Try to avoid as many transitions, elbows, and long run as possible. This may performance of the hood.
-Use duct tape to seal the joints between pipe sections.
-If necessary, prepare back wall frame with cross framing lumber for secure i Using references on Table 2 and measurements on page 15, decide the level of t lumber. Refer to Figure 9.
Figure 8
Hood Preparation before Installation
-Temporarily wire the hood to test for proper operation before installing.
-Peel protective film off the hood and the duct cover (if any).
-Attach the
Hood Installation
CAUTION: If required to move the cooking range to install the hood, turn off the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
3.If necessary, attach two rubber stands (provided) withscrewstwo (4x8(provided)mm) to the back of the hood.
8