Kobe Range Hoods RA3836S, RA3830S Under the Cabinet Installation Safety Warning

Page 7

UNDER THE CABINET INSTALLATION

SAFETY WARNING

HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES IF IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING, OR SERVICING.

Preparation before Installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.

-Decide the location of the venting pipe from the hood to the outside. Refe

-A straight, short venting run will allow the hood to perform more efficient

-Try to avoid as many transitions, elbows, and long run as possible. This m the performance of the hood.

-Temporarily wire the hood to test for proper operation before installing.

-Peel protective film off the hood (if any).

-For installing under the cabinets with recessed bottom, attach 4-inch wide w strips (not included) on each side. Refer to Figure 2.

-Measure and create access opening for electrical wires under the cabinet.

Figure 1

Hood Installation

CAUTION: If required to move the cooking range to install the hood, turn off the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

1.Puncture the knockout holes. Refer to Figure 3.

5

Image 7

Contents Kobe Brand Range Hood Read and Save These Instructions Important Safety Instructions Please Read this Section Carefully Before InstallationWhat to Do In The Event Of a Range Top Grease Fire Activating any switch may cause ignition or an explosionComponents of Package For Stand Alone with Optional Duct Cover InstallationPlease Read Entire Instructions Before Proceeding For Under the CabinetPreparation before Installation Under the Cabinet Installation Safety WarningSafety Warning Connect the electrical wires Stand Alone Installation Page Final Assembly Attach Together Wiring to Power SupplyCheck all lights and fan operation. for the homeowner Operating Instructions Top rack dishwasher safe MaintenanceReplace protective cover Plug in range hood Specifications All measurements in are millimeters Measurements & DiagramsHood-Mounting Bracket Model NO. RA3830S Parts ListOptional Duct Cover Model NO. RA3830S KEY Code Circuit DiagramClaims will not be Accepted After the Allocated Days DisclaimerThis warranty applies only Within U.S.A. and Canada WarrantyWarranty Certificate TWO-YEAR Warranty Service PeriodConsequential Damage ServiceMAY not Apply to YOU Implied WARRANTIES/STATE LAW Model No Product RegistrationRegister Your Product Record the Following Information for Your Record