4.Using references on Table 2 and measurements on page 15, decide the leveling p the hood. Position two mounting screws (not provided) on the wall, leaving 1/ from the wall as shown in Figure 11.
5.Align
Hood- |
|
|
| Mounting | |
Mounting |
| |
| Screws | |
Bracket |
| |
|
| |
| Figure 10 | |
| ||
Duct Cover Installation
6.Mark the position of the duct
7.Connect electrical wires. Refer to Wiring to Power Supply. If necessary to electrical wire connections, push wires back into the wiring box. Access the connections underneath the hood by removing the bottom casing from the six scr Before reattaching the bottom casing, make sure wires do not slip between moto impellers, or any moving parts to prevent any damage.
8.Use aluminum or steel pipe to connect the exhaust opening on the hood to the d above. Use duct tape to make all joints secure and air tight.
9.Slide the inner duct cover up 2 inches before sliding the entire duct cover on Refer to Figure 13.
Figure 12
10.Adjust the height of the inner duct cover to the duct
11.Fasten outer duct cover to plastic plate on the hood with four (4x8 mm) screw
9