UNDER THE CABINET INSTALLATION – TOP VENT
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.
-Decide the location of the venting pipe from the hood to the outside. Refer to Figure 1.
-A straight, short venting run will allow the hood to perform more efficiently.
-Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the hood.
-Temporarily wire the hood to test for proper operation before installing.
-Peel protective film off the hood (if any).
-For installing under the cabinet with recessed bottom, attach
-Measure and create access opening for electrical wires under the cabinet.
-Cut the multi duct exhaust according to the size of the venting pipe. Refer to Figure 3.
Figure 1 | Figure 2 |
Figure 3
6" Round Vent | 7" Round Vent | |
|
|
|
Hood Installation
CAUTION: If required to move the cooking range to install the hood, turn off the power on an electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.
1.Puncture the knockout holes on the hood as shown in Figure 4. 7