Duct Cover Installation
5. Use 8” aluminum or steel pipe (follow building codes in your area) to connect the ducting transition on the hood to the ductwork above. Use duct tape to seal and secure joints as shown in Figure 15. Slide the duct cover onto the hood.
6.Use 3/16” x 3/8” screws (provided) to attach duct cover to hood.
Figure 15
Final Assembly
CAUTION: Install heating lamps last.
7.Drop Oil Tunnel into support structure. Refer to Figure 7.
8.Angle baffle filter toward back of hood . Refer to Figure 8.
9.Push baffle filter up until almost level .
10. Slide forward into recess at front of hood . | Figure 16 |
11.Lower baffle filter and slide back until it fits into resting position .
12.Repeat for all baffle filters and spacers. Refer to Measurements and Diagrams on page 21 for baffle filter and stainless spacer arrangement.
13.Install heating lamps (not provided), 120 Volts 250 Watts max. each.
14.Turn power ON in control panel. Check all lights and fan operation.
15.Make sure to leave this manual for the homeowner.
Figure 17
11