Zanussi ZGF 642 manual Operation, HOB Burners, Burner Minimum Maximum, Diameter

Page 5

Operation

HOB BURNERS

To light a burner, turn the relevant knob anticlockwise to maximum position and push down the knob to ignite.

If the burner does not ignite, turn the control knob to zero, and try again.

i

When switching on the mains, after installation or a power cut, it is quite normal for the spark generator to be activated automatically.

To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table).

Burner

minimum

maximum

 

diameter

diameter

 

 

 

Large (rapid)

160 mm.

240 mm.

Medium (semi-rapid)

120 mm.

220 mm.

Small (Auxiliary)

80 mm.

160 mm.

 

 

 

i

If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat.

As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.

Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite.

If the control knobs become difficult to turn, please contact your local Electrolux Service Centre.

6

Image 5
Contents GAS HOB Model ZGF Child Safety Important Safety InformationService During UseContents When the HOB is First Installed InstallationDescription of the Hob Hob TopHOB Burners OperationBurner Minimum Maximum DiameterHobTop Maintenance and CleaningPan Supports BurnersSomething Not Working? Symptom SolutionZanussi Guarantee Conditions Service and Spare PartsPeace of Mind for 24 Months Customer CareEngineer technical data Instructions for the InstallerOverall Dimensions CUT OUT DimensionsLocation Important safety requirementsDimensions are given in mm InstallationGas Connection Cut Out SizeFitting the Hob into the worktop BuildingThis HOB Must be Earthed Electrical connectionsTaps Ignitor Switches Ignitor Unit Wiring DiagramEarth Continuity Check Fault FindingPreliminary Electrical Systems Check Ignition System / Gas Ignition Commissioning ProcedurePressure Testing Servicing To Adjust the GAS Rate