TC electronic SDN BHD Gold Channel user manual Utility Display, Config, Card

UTILITY

The Utility Display

In Utility you can choose between CONFIG, CARD and MIDI. Use the < > Menu keys to select between the three displays.

The Config. Page

In the Config. page you can set up a number of global parameters for the Gold Channel such as memory protect, MIDI bulk dump etc.

Display Viewing Angle

Adjust for best contrast of the LCD display.

Clip Hold

Here you can set the time you want the Clip indicator to stay lit after a clip is detected (Off, 5sec, 30sec or 60sec).

PAD range

Selects how many of the PAD values you want to have access to. If set to 20 you are only able to scroll between 0 and 20 dB, when set to 40 you have 0, 20 and 40 dB available and if set to 60 you have 0, 20, 40 and 60 dB PAD choices. This is done to make it easier for you to control the PAD, because if you only use 0 and 20 dB PAD in your daily work, it’s irritating to scroll through 40 and 60 every time you press the PAD key.

Param. dial direction

This parameter enables you to change the cursor direction when dialing the Parameter wheel in parameter lists. Choose whether the cursor should move up or down when dialing the parameter wheel clockwise.

Auto Pages

Selects how the Gain and Signal pages shall react when parameters are changed. Enter And Exit cause the pages to pop up and disappear automatically. Enter At Touch, causes the pages to pop up automatically but not to change back automatically. Off means that nothing will happen automatically

Double Click

Turns the bypass buttons double click function on/off.

Fader Control

Selects what channels the TC Master Fader should control on the Master output level. When set to Stereo the two outputs will always be identical.

Fader Calibration

Press Enter to enable calibration of the optional TC Master Fader connected to the External Control input. Follow the instructions in the display.

Protect

Sets the Preset Protect function On/Off.

Protect Low limit

Sets the lower limit of the preset protect. The current number is included in the protection.

Protect High limit

Sets the higher limit of the preset protect. The current number is included in the protection.

The Card Page

The Card page features a number of tools for handling cards, including preset copying to and from a Card.

Use the Parameter wheel to scroll, and the Value wheel to change values.

Card type: SRAM PCMCIA, type 1, min. 64 KBytes to 2 MB.

Show card status

This function makes it possible to check the status of your PC- card. The Gold Channel will be able to display the size of the card, the write protection status, the number of presets on the card and the amount of free space.

NOTE: This information will only be available when the card is Gold Channel formatted or contains Gold Channel presets. The Gold Channel will read “New Card” when the card is inserted, if the card is not formatted.

Format/Erase Card

This function will Format and Erase the PC-card. Press Enter twice to confirm this action.

WARNING: This action will overwrite ALL existing presets on the current Card.

USER/CARD BANK COPY

This section makes it possible to copy a specified group of presets to or from a specific space on a card. For example: You want to copy User preset 10-15 from the Gold Channel to preset 5-10 on your card. Now set the “User bank preset start” at 10 (because you to start the group of presets at #10), the “Card bank preset start” at 5 (because you want the first copied preset to start at #5), the “Number of presets” to 5 (because that is the number of presets you want to copy). Now select Copy “From User bank to Card” scroll to “Execute copy” and press Enter twice to confirm the copy operation.

User bank preset start

This parameter determines where the copy action should start in the internal User bank.

Card bank preset start

This parameter determines where the copy action should start in the Card bank.

Number of presets

This parameter sets the number of presets to be copied.