Fitting Into the Cabinet

IMPORTANT: Ensure that the oven is switched off at the wall before any further work is carried out.

Using a tape measure establish the internal width of the cabinet. Refer to page 7 if greater than 565mm.

Position the appliance in front of the cabinet. See Fig. 7.

Take out all oven furniture before installation to reduce the weight you need to lift. The oven door should be taped up to keep it closed whilst lifting.

To place the appliance into the cabinetry follow the procedure below:

N.B. Two people will be required to carry out the lifting procedure.

Do not try to lift or move the appliance by pulling the door handles.

a)Each person should squat either side of the appliance.

b)Tilt the appliance so that your hands can support the underside of the appliance.

c)Keeping your back straight, raise the appliance to the cabinet by straightening at the knees.

d)Rest the rear underside of the appliance on the cabinet floor while your hands support the front.

e)The appliance can be pushed fully into the cabinet. Take care to avoid fouling the mains lead.

f)Ensure the appliance is central in the cabinet and level.

g)Do not remove spacers fitted behind fixing holes.

h)When the appliance is fully housed screw the stability screws (supplied with the appliance) into the side of the cabinet taking care not to distort the side trims (See Fig 8). It is advisable to turn each screw alternatively to avoid damaging the trims.

i)Switch on the appliance then refer to the operating instructions in the following pages.

Fig. 7

Fig. 8