In the event of a fault trip, the display will show the fault code and the STATUS indicator will begin to blink red. Pressing the UP Arrow before the fault is reset will display the status of the drive at the time of the fault. More than one display symbol may be shown to better define the cause of the fault.
Faults can be reset by the following methods:
1)Pressing the Keypad STOP Key
2)Simultaneously closing the FWD and REV terminals at the Control Terminal Strip
3)Removing AC Line Power
4)By the Auto Restart feature
The following table lists the available Fault Codes. Please note that only faults F11 through F20 will be reset by the Auto Restart feature.
Fault Codes
Fault Code Description
F01 Computer Malfunction
F02 Parameter Block Fault
F03 Bus Current Measurement Fault
F04 Power Supply Overload
F05 No DC Bus Voltage
F06 Output Short Circuit
F07 External Trip Fault
F10 Auto Restart Fault
F11 Ground Fault
F13 DC Bus Overvoltage
F16 Overcurrent During Acceleration
F17 Overcurrent During Deceleration
F18 Overcurrent While Running
F19 Heatsink Overtemperature
F20 Timed Overload