Symbol | Description |
FWD | Forward direction commanded |
REV | Reverse direction commanded |
PRG | Program Mode Selected (Steady) |
| Parameter Value may be changed (Blinking) |
SET | Drive is Stopped or running frequency being set |
OV | Overvoltage condition |
UV | Undervoltage condition |
LIM | Running in Torque Limit |
OC | Running in Overcurrent condition (Blinking) |
| Overcurrent Fault (Steady) |
TEMP | Running in Overtemperature condition (Blinking) |
| Overtemperature Fault (Steady) |
DB | Dynamic Brake circuit is active |
rpm | Revolutions per minute indication |
Hz | Frequency in Hertz |
h | Time in Hours |
s | Time in Seconds |
A | Output Current in Amperes |
V | Output Voltage in Volts |
%Display is in percent of units
C | Degrees Centigrade |
Stop Mode
At the time of initial power up and after a Stop command the control is in the Stop Mode and the display will show the set output frequency of the control.
Run Mode
When a Forward or Reverse Run command is given the control is in the Run Mode and the display will show one of several output status values. The displayed output can be Output Frequency, Output Current, Drive Load, or RPM. The displayed output is selected by parameter
Operation
