Empire Comfort Systems CIBV-30-20 installation instructions Introduction

Page 5

INTRODUCTION

Introduction

Always consult your local Building Department regarding regulations, codes or ordinances which apply to the installation of a vented fireplace heater.

Instructions to Installer

1.Installer must leave instruction manual with owner after installation.

2.Installer must have owner fill out and mail warranty card supplied with heater.

3.Installer should show owner how to start and operate heater and thermostat.

General Information

This appliance is design certified in accordance with American National Standard /CSA Standard ANSI Z21.88 and CSA 2.33 by the Canadian Standards Association, as a Vented Fireplace Heater and must be installed according to these instructions.

Any alteration of the original design, installed other than as shown in these instructions or use with a type of gas not shown on the rating plate is the responsibility of the person and company making the change.

Important

All correspondence should refer to complete Model Number, Serial Number and type of gas.

Notice: During initial firing of this unit, its paint will bake out and smoke will occur. To prevent triggering of smoke alarms, ventilate the room in which the unit is installed.

Qualified Installing Agency

Installation and replacement of gas piping, gas utilization equipment or accessories and repair and servicing of equipment shall be performed only by a qualified agency. The term "qualified agency" means any individual, firm, corporation or company which either in person or through a representative is engaged in and is responsible for (a) the installation or replacement of gas piping or (b) the connection, installation, repair or servicing of equipment, who is experienced in such work, familiar with all precautions required and has complied with all the requirements of the authority having jurisdiction.

State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts.

The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54.*

*Available from the American National Standards Institute, Inc., 11 West 42nd St., New York, N.Y. 10036.

High Altitudes

When installing this unit at an elevation above 2000 feet (in the United States) it may be necessary to decrease the input rating by changing the existing burner orifice to a smaller size. Generally, input should be reduced 4 percent for each 1000 feet above sea level. However, if the heating value of the gas has been reduced, this general rule may not apply. Check with local gas utility for proper orifice size identification.

APPLIES TO CANADIAN MODELS ONLY FOR PROPANE GAS.

Altitude: 0-4,500 feet (0-1370 m) without orifice change.

APPLIESTO CANADIAN MODELS ONLYFOR NATURAL GAS.

Altitude 0-2,000 feet (0-610m) without orifice change.

Cet appareil est équipé pour des altitudes compris entre 0 et 2000 pieds (0-610m) seulement.

For installations from 610-1370 metres (2,000-4,500 ft.) the orifice size (DMS) for natural gas is 39. See data plate for additional information.

For high altitude installations consult the local gas distributor or the authority having jurisdiction for proper rating methods. If the installer must convert the unit to adjust for varying altitudes, the information sticker (illustrated below) must be filled out by the installer and adhered to the appliance at the time of conversion.

THE CONVERSION SHALL BE CARRIED OUT BY A MAN- UFACTURER'S AUTHORIZED REPRESENTATIVE IN AC- CORDANCE WITH THE REQUIREMENTS OF THE MANU- FACTURER,PROVINCIALORTERRITORIALAUTHORITIES HAVING JURISDICTIONAND INACCORDANCEWITHTHE REQUIREMENTS OF THE CAN/CGA-B141.1 OR CAN/CGA- B141.2 INSTALLATION CODES.

LA CONVERSION DOIT ÊTRE EFFECTUÉE CONFOR- MÉMENT AUX RÉGLEMENTATION PROVINCIAUX EN CAUSE ETAUX EXIGENCES DES CODES D'INSTALLATION CAN/CGA-B149.

This appliance has been converted for use at an altitude of

Orifice size

 

 

 

 

Manifold Pressure

 

Input (Btu/h)

 

 

 

Fuel Type

 

 

 

Date of Conversion

 

 

Converted by

 

 

Cet appareil a été converti au

InjecteurPression à la tubulure d'alimentation Déoit calorifique

15627-5-0807

Page 5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Installation Instructions Table of Contents This is a Heating Appliance Important Safety InformationLP-GAS Warning Odor Safety Information for Users of LP-GASIntroduction CIBV-30 SpecificationsGAS Supply Installing a New Main Gas CockRecommended Gas Pipe Diameter Checking Manifold PressureClearances Installation on Rugs and TileDetailed Instructions Follow Assembly of Stove CastingAppliance Hardware Package Assembly of Stove Casting 15627-5-0807 Parts List Optional Stone Inlay InstallationInstallation of Optional Stone Inlay LOG Placement Wire Channel InstallationOperating Guidelines Vent Safety Shutoff SystemVenting VentingLiner and Insulated Liner Insulated Vent Enclosure FigureLighting Instructions For Your Safety Read Before LightingMain Burner Flame Characteristics Pilot Flame CharacteristicsAir Shutter Adjustment Cleaning the Log Set and FireboxWiring Cleaning Procedure MaintenanceMaintenance & Service Instructions General Glass Information Glass CleaningGlass Assembly Replacement Frequent pilot outage problem TroubleshootingPilot and main burner extinguish while in operation Glass sootsParts List for CIBV-30-20 HOW to Order Repair PartsParts View for CIBV-30-20 Parts List for Stove Casting Parts View for Stove Casting Installing Optional CIB-2 Blower Optional Blower Installation InstructionsRefer to Wire Channel Installation, Fan ControlWiring CleaningBlower Motor Index Part No. No. DescriptionFAX

CIBV-30-20 specifications

Empire Comfort Systems CIBV-30-20 is a versatile and efficient heating solution designed to meet the needs of both residential and commercial spaces. This direct vent gas fireplace boasts an array of features that make it a popular choice for those looking to enhance their indoor environment with warmth and style.

One of the main features of the CIBV-30-20 is its sleek and contemporary design. The fireplace comes with a clean-faced front that allows for a seamless integration into any decor. Its compact size, with a 30-inch width, makes it suitable for various settings, from cozy living rooms to larger commercial spaces. The large viewing area maximizes the sight of the flames, providing an inviting ambiance and a warm atmosphere.

Performance is a key characteristic of the CIBV-30-20. It operates using natural gas or propane, allowing users to choose the fuel type that best fits their needs. With an impressive heat output of up to 25,000 BTUs, this fireplace efficiently heats the room, ensuring comfort during the cold months. Empire Comfort Systems has engineered the fireplace to deliver consistent and reliable performance, making it an ideal choice for year-round use.

Another significant technology integrated into the CIBV-30-20 is its direct vent system. This feature allows for safe and efficient venting, as it draws air from the outside to fuel the fire, thus eliminating the risk of indoor air pollution. The balanced flue technology ensures that combustion gases are vented outside, maintaining good air quality indoors.

In terms of controls, the CIBV-30-20 is equipped with a reliable millivolt system, which allows for easy operation without the need for electricity. For added convenience, optional remote control kits are available, enabling users to adjust flame height and heat levels from a distance.

The Empire Comfort Systems CIBV-30-20 also prioritizes efficiency. With an efficiency rating of up to 75%, it provides substantial warmth while minimizing energy consumption, making it an eco-friendly heating option.

In summary, the Empire Comfort Systems CIBV-30-20 combines modern aesthetics with advanced heating technology. Its features, including direct vent capability, high heat output, and efficient performance, make it a standout solution for anyone seeking a reliable and stylish heating appliance. Whether for home or business use, the CIBV-30-20 is designed to deliver warmth, comfort, and a welcoming ambiance.
Top Page Image Contents