Zanussi zdf231 user manual Drain hose, Electrical connection

Page 24

Drain hose

Connect drain hose to the sink. Secure it with the supplied hose clamp.

Required height: 30 to 100 cm above bottom of the dishwasher.

Ensure that the hoses are not kinked, crushed or entangled.

When connecting the drain hose to an under sink trap spigot, the en-

tire plastic membrane

(A)must be removed. Failure to remove all the membrane will result in food particles building up over time eventually blocking the dishwasher drain hose spigot.

If you use a drain hose extension the total length should not be longer than 4 metres. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.

Electrical connection

CAUTION!

Safety standards require the appliance to be earthed.

Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed.

The fuse rating is also to be found on the rating plate.

24

Always plug the mains plug into a correctly in- stalled shockproof socket. Multi-way plugs, connectors and extension cables must not be used.

This could constitute a fire hazard through over- heating.

If necessary, have the domestic wiring system socket replaced. In case that the electrical ca- ble has to be replaced, contact your local Serv- ice Force centre.

The plug must be accessible after the appliance has been installed.

Never unplug the appliance by pulling on the cable. Always pull the plug.

The manufacturer accepts no liability for failure to observe the above safety precautions.

Image 24
Contents Dishwasher ZDF Contents Safety information General safetyChild safety Correct useInstallation Control panelStarting the washing programme Delay start button Programme selector indicator light Indicator lightsWashing programmes First useWhen using tablets that integrate rinse aid and detergent Set the water softenerSetting the water softener manually see table Setting the water softener electronically see tableWater hardness Clarke Mmol/l Use of saltFilling with dishwasher salt Use only special salt suitable for dishwashersFilling with rinse aid Adjusting the dosage of rinse aid Loading cutlery and dishesAre of limited suitability Adjusting the height of the upper basket Maximum height of the dishes Upper basketLower basket Use of detergent To move to the higher position proceed as fol- lowsCare and cleaning Cleaning the filtersUnloading the dishwasher Cleaning the spray arms External cleaningInternal cleaning Prolonged periods of non- operationFrost precautions Environmental concernsMoving the machine Packaging materialFault code and malfunction Possible cause and solutionSomething not working Wash results are not satisfactory Technical data Consumption valuesInstallation Full load 12 standard place settingsHints for test institutes Water connection Inlet hoseDrain hose Electrical connectionGuarantee conditions Guarantee/Customer ServiceFitting under a counter LevellingEuropean Guarantee ExclusionsPage Page Page Page Page 156996240-00-15032007 Subject to change without notice