Zanussi zdf231 user manual Water connection, Inlet hose

Page 23

Water connection

WARNING!

The dishwasher must not be connected to open water appliances or instantaneous water heat- ers. This dishwasher may be fed with either hot (max. 60°) or cold water. Nevertheless we ad- vise you a cold water supply.

WARNING!

Only use, for connection to the water mains, new hose-set; old hose-set must not be reused.

Inlet hose

CAUTION!

If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes be- fore connecting the inlet hose.

Connect the inlet hose to a water tap with an external thread of 3/4 .

The inlet hose can be turned either to the left or the right to suit the installation by means of the locknut. The locknut must be correctly fitted to avoid water leaks.

23

Image 23

Contents Dishwasher ZDF Contents Correct use Safety informationGeneral safety Child safetyControl panel InstallationStarting the washing programme Indicator lights Delay start button Programme selector indicator lightFirst use Washing programmesSet the water softener When using tablets that integrate rinse aid and detergentUse of salt Setting the water softener manually see tableSetting the water softener electronically see table Water hardness Clarke Mmol/lUse only special salt suitable for dishwashers Filling with dishwasher saltFilling with rinse aid Loading cutlery and dishes Adjusting the dosage of rinse aidAre of limited suitability Lower basket Adjusting the height of the upper basketMaximum height of the dishes Upper basket To move to the higher position proceed as fol- lows Use of detergentUnloading the dishwasher Care and cleaningCleaning the filters Prolonged periods of non- operation Cleaning the spray armsExternal cleaning Internal cleaningPackaging material Frost precautionsEnvironmental concerns Moving the machineSomething not working Fault code and malfunctionPossible cause and solution Wash results are not satisfactory Consumption values Technical dataHints for test institutes InstallationFull load 12 standard place settings Inlet hose Water connectionElectrical connection Drain hoseLevelling Guarantee conditionsGuarantee/Customer Service Fitting under a counterExclusions European GuaranteePage Page Page Page Page 156996240-00-15032007 Subject to change without notice