Zanussi DA 6141 manual Filling with salt, May cause corrosion, Refill indicator window, Float

Filling with salt

Attention!

Only use salt specifically designed for use in dishwashers.

All other types of salt not specifically designed for use in dishwasher, especially table salt, will damage the water softener.

Only fill with salt just before starting a washing programme. This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine, which

may cause corrosion.

The salt container will require topping up periodically.

According to the model, an indicator reminds you when filling with salt:

A) The salt	cap has a	refill indicator window	in the centre.
A green	float	is clearly visible when there is salt inside
the container, and almost disappears when the salt has
finished reminding you to add salt.

SR11

B) A salt indicator light	on the control panel will come on
when the salt has finished.

The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher

remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected..

Do not worry if water over flows from the unit when filling with salt, this is quite normal.

4

SR15

1.Unscrew the cap of the salt container.

SR16

2.Pour 1 litre of water inside the container

(this is necessary only before filling with salt for the first time).

SR17

3.Using the funnel provided, pour in the salt until the container is full.

SR18

4.Remove any trace of salt on the screw thread or on the gasket.

SR19

5.Screw on the cap tightly.