Building-in
This dishwasher is designed to be fitted under a kitchen counter or worksurface.
It is essential that the recess dimensions indicated in the diagram are followed.
No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through.
The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm).
A distance of 2 mm should be allowed between the top of the dishwasher and the counter top.
Adjusting the height of the appliance
To adjust the height proceed as follows:
1.Loosen or tighten the two front feet.
2.The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right.
A pad is supplied for the rear foot to make sliding the appliance in and out of the recess easier.
To fit the pad, press it onto the rear foot.
If required, the dimensions of this pads can be reduced by breaking it where marked.
| 596 |
| 880 |
|
| ⎟ | |
|
| 820 | |
|
|
| |
878 |
| 550 | 600 |
⎟ |
| max |
|
818 |
|
| |
|
|
| |
- |
|
|
|
| + |
|
|
II64 |
|
|
|
II52 |
Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers, either side of the cabinet.
If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.
IN11 |
IN12 |
29 | PFI20UK |